BevRC
FRSKY FIRMWARE UPDATER TOOL
Frsky products." />
,
Used for the firmware update of Frsky products.BevRC
FRSKY V8FR-II RX
FrSKY ACCST technology is proven, approved by many model associations, ..." />
Operating voltage | 3.0~16V(HV Version) |
Power consumption | 30mA |
Resolution | 3072 |
Latency | 22ms |
Range | 1.5km-2.5km |
Dimensions | 44 x 24 x 14 mm |
Weight | 9.3g |
Features:, Advanced Continuous Channel Shifting Technology (ACCSTis our advanced tecnology it shifts channel hundred times per second and there is no signal conflicts and interruptions) robust frequency agility., Receiver Specification:, Number of channels: 8,
FrSKY ACCST technology is proven, approved by many model associations, ...BevRC
FRSKY TFR8SB- COMPATIBLE WITH FUTABA FAAST RADIO WITH SBUS AND RSSI PORT
FASST 2.4GHz Air Systems (7CH Mode/Multi Mode) | 6EX, 7C, TM-7, TM-8, T8FG, T10C, TM-10, T10CG, T12Z, T12FG, TM-14, T14MZ, etc |
Model | TFR8SB (8CH FASST compatible receiver with RSSI & SB ports) |
Dimension | 44.5*27.5*17mm |
Operating Voltage Range | 3.5~10V |
Operating Temperature Range | -10℃~80℃ |
Mode A | RED LED blinks |
Mode B | GREEN LED blinks |
:11.5g, :, 14ms (FS – Normal Speed Mode), Note: Be sure that when using battery or regulated output from ESC, the capacity must meet the usage conditions of servos., Use native failsafe position preset on the transmitter side:, If not disabling failsafe on the transmitter side, TFR8SB will use native failsafe position preset on the transmitter side., Set failsafe on TFR8SB side:, TFR8SB supports failsafe function for all channels. Follow the steps below to set failsafe on TFR8SB:, 1) Bind the receiver first, and disable failsafe on the transmitter side;, Note: HS mode is only applied for high-speed digital servos. Other servos should select FS mode, otherwise servos will get hot or even burn out., Note: Do not perform linking procedure while motor’s main wire is connected or engine is operating, otherwise damage may occur. After linking is completed, recycle the receiver power and check if the receiver is really under control by linked transmitter.,
It's a good choice for your multi-rotor with Naza or ...BevRC
FRSKY TEMPERATURE SENSOR
FrSky TEMS-01 Telemetry Temperature Sensor (for use with FrSky Telemetry ..." />
Measurement Range:, -20~250 degrees Celsius/ -4~482 degrees Fahrenheit, Accuracy:, 1 degree Celsius/ 1 degree Fahrenheit, Installation:, Use zip ties to hold the temperature sensor tightly against the accessory that requires temperature reading.,
FrSky TEMS-01 Telemetry Temperature Sensor (for use with FrSky Telemetry ...BevRC
FRSKY VARIMETRE SENSOR
FrSky FVAS-01 Telemetry Variometer Sensor (for use with FrSky Telemetry ..." />
Measurement Range of Altitude | 0~9000m |
Accuracy:1m, Installation:, Use double-sided tape to install the variometer sensor on any appropriate surface of the airframe., *Note:, Wind will affect the altitude reading.,
FrSky FVAS-01 Telemetry Variometer Sensor (for use with FrSky Telemetry ...RangeVideo
FRSKY 2.4GHZ FUTABA COMBO PACK
FrSKY ACCST technology is proven, approved by many model ..." />
Futaba | 3PM, 3PK, 7U, 8U, 9C, 10C, 9Z, AND FN-Series, T10C, FC-18, FC-28. |
Hitec | Optic 6, Eclipse 7, Prism 7 |
WFLY | WFT09, WFT-08 |
Features:, - Advanced Continuous Channel Shifting Technology (ACCST is our advanced tecnology it shifts channel hundred times per second and there is no signal conflicts and interruptions) robust frequency agility., Transmitter Module is compatible with the following transmitters:, , V8FT:,
Details FrSKY ACCST technology is proven, approved by many model ...RangeVideo
FRSKY 2.4GHZ PATCH ANTENNA
FrSky RC system to ..." />
Connector | RP-SMA Female |
ReadyMadeRC
EZUHF JR-FRSKY MODULE TRANSMITTER
- Recommended tx antenna | Diamond SRH771 |
http | //fpvlab.com/forums/showthread.php?3000-EzUHF-Rx-Tx-firmware-upgrade-procedure |
http | //fpvlab.com/forums/showthread.php?2999-EzUHF-Rx-Tx-driver-installation |
http | //fpvlab.com/forums/showthread.php?2998-EzUHF-Rx-Tx-bind-procedure |
Notice: The use and operation of this product in the USA and many other countries requires an amateur/ham radio license, and some countries may forbid its use entirely. It is the responsibility of the purchaser to ensure that the use of this product meets the requirements imposed by your government’s rules and regulations for RF devices. Do not purchase this product if you are unsure of the government requirements or are not able to comply with them. ReadyMadeRC cannot be held responsible for your actions if you purchase and/or use this product in violation of your government's regulations.,
- 500mW of EzUHF Power - JR Module, compatible with ...ReadyMadeRC
FRSKY - TFR4SB 4CH FASST S.BUS RECEIVER
Compatibility:, , Dimension:, , Weight:, , Operating Voltage Range:, , Number of Channels:,
FEATURES 1) SB port is compatible with Futaba S.BUS servos ...ReadyMadeRC
FRSKY - TFR8SB 8/16CH FASST S.BUS RECEIVER WITH RSSI OUTPUT
Compatibility:, , Dimension:, , Weight:, , Operating Voltage Range:, , Number of Channels:, , Operating Temperature Range:,
FEATURES 1) SB port is compatible with Futaba S.BUS servos ...ReadyMadeRC
FRSKY - X8R-PCB 8/16CH TELEMETRY RECEIVER
FrSky DFT/DJT/DHT/DHT-U in D_mode FrSky Taranis X9D/XJT in ..." />
,
SPECIFICATIONS Compatibility FrSky DFT/DJT/DHT/DHT-U in D_mode FrSky Taranis X9D/XJT in ...ReadyMadeRC
FRSKY - UPGRADE CABLE FOR DFT/DJT/DHT
FrSky Upgrade Cable for DFT/DJT/DHT/8ch Telemetry Receiver/Sensor Hub/FLD-02" />
,
FrSky Upgrade Cable for DFT/DJT/DHT/8ch Telemetry Receiver/Sensor Hub/FLD-02ReadyMadeRC
FRSKY - SERIAL ADAPTER RS232 CONVERTER
FRSky Serial Adapter used for firmware updates." />
,
FRSky Serial Adapter used for firmware updates.ReadyMadeRC
FRSKY - DHT-U MODULE TRAINER CONNECTION FOR FUTABA
FrSky Upgrade Cable for DFT/DJT/DHT/8ch Telemetry Receiver/Sensor Hub/FLD-02" />
,
FrSky Upgrade Cable for DFT/DJT/DHT/8ch Telemetry Receiver/Sensor Hub/FLD-02ReadyMadeRC
FRSKY V8FR-II 8 CHANNEL RECEIVER
FrSky modules (V8_mode & D_mode), receive ..." />
,
FEATURES Compatible with all FrSky modules (V8_mode & D_mode), receive ...