RCModelScout.

GetFPV

FUTABA SQUARE ADAPTER FOR AEROSIM RC FLIGHT SIMULATOR

,

GetFPV

LAYERLENS REPLACEMENT VELCRO STRAP

,

GetFPV

LAYERLENS GOPRO LENS PROTECTION (FOR GOPRO 1 & 2)

NOTE: This version of LayerLens is not compatible with the GoPro Hero 3. A new LayerLens for the Hero 3 will be released soon., For this reason, FPV Manuals has developed LayerLens. LayerLens brings the most important part of the original GoPro case back: the protective lens; without adding much weight or size. LayerLens weighs only 11g — about 10% of the weight of the GoPro case. LayerLens is a precision laser cut frame that holds the protective glass lens found in the GoPro's case. LayerLens is pushed onto the GoPro’s built in lens. It sits tightly in place and is secured by an included velcro band. In case of a crash that scratches LayerLens’ glass lens, you can easily swap out the scratched protective lens and replace it with one of the lenses that are readily available by GoPro as part of their “Lens Replacement Kit” (which includes 2 lenses for $14 to $20 USD).,

GetFPV

LAYERLENS FOR GOPRO3 (V2)

For this reason, FPV Manuals developed LayerLens. LayerLens brings the most important part of the original GoPro case back: the protective lens; without adding much weight or size. Fully assembled, LayerLens for the GoPro 3 weighs only 7.5g — a small fraction the weight of the full GoPro case. LayerLens has become the standard lens protection product in the fields of RC and FPV where a GoPro is used outside of its standard housing.,

GetFPV

LAYERLENS FOR GOPRO 3 REPLACEMENT LENS (1PCS)

,

GetFPV

DJI NAZA M MULTI-ROTOR STABILIZATION CONTROLLER

Naza-M offers three types of control modes: GPS Atti. Mode(with GPS module), Atti. Mode, Manual Mode. Switch among the three modes to adjust to different flight environments. Naza-M can adjust automatically and intelligent switch between GPS Atti.mode and Atti. Mode to ensure the safety and security of the flight., Immediately Mode: By using this mode once the motors start and throttle stick has exceeded 10%, motors will stop immediately when throttle stick is back under 10% again. In this case, if you push the throttle stick over 10% within 5 seconds of the motors stopping, motors will re-start .If you don’t push throttle stick within three seconds of the motors starting, the motors will stop automatically., Intelligent Mode: In Manual, only executing CSC will stop motors. In Atti Mode. any one of following four cases will stop motors:, a) You don’t push throttle stick after motors start in three seconds;,

GetFPV

IMMERSIONRC EZUHF TX AND RX COMBO

,

GetFPV

IMMERSIONRC 5.8 GHZ SPIRONET CP PATCH ANTENNA

,

GetFPV

SONY ACTIONCAM RC STAND

,

GetFPV

WHITE NYLON STANDOFF SET

,

GetFPV

EZUHF 4 CHANNEL RECEIVER

GetFPV

TIGER MOTOR M5 CW PROP ADAPTER NUT

,

GetFPV

TIGER MOTOR MT-4006 SERIES BEARINGS

,

GetFPV

IBCRAZY 2.4 GHZ 10DBIC CROSSHAIR ANTENNA

GetFPV

TBS LIPO VELCRO STRAPS (2PCS)

,