ReadyMadeRC
5.8 GHZ CLOVERLEAF WHIP ANTENNA (RHCP) (SINGLE, STRAIGHT)
http | //www.rcgroups.com/forums/showpost.php?p=18484051&postcount=786 |
ATTENTION: It has come to my attention that there is a minor, fixable incompatibility with some Airwave based receivers. The standard 5.8GHz receivers may require a minor modification to fix a problem where the receiver tries to put a small DC bias voltage on the antenna. Please see this forum thread post for the (relatively easy) fix:, , Radiation pattern:,
This amazing creation is built by Alex Greve (IBCrazy). The ...ReadyMadeRC
1500MW 1300MHZ TRANSMITTER - BLACK EDITION READYMADERC US
Weight of transmitter with heat sink case, not including wires or antenna | 87g |
Weight with bare module without heat sink, not including wires or antennas | 37g |
bare module dimensions | 70*37*7mm |
*Notice: The use and operation of this product in the USA and other countries requires an amateur/ham radio license, and some countries may forbid its use entirely. It is the responsibility of the purchaser to ensure that the use of this product meets the requirements imposed by your government’s rules and regulations for RF devices. Do not purchase this product if you are unsure of the government requirements or are not able to comply with them. ReadyMadeRC cannot be held responsible for your actions if you purchase and/or use this product in violation of your government's regulations.,
WE'VE OPENED UP A WHOLE NEW FREQUENCY FOR LEGAL USE ...ReadyMadeRC
1000MW 1300MHZ TRANSMITTER - NEW CUSTOM READYMADERC INTL VERSION
Output Power | 1000mW (see above) |
Nominal output impedance | 50 ohms |
Operating voltage | 10.5-13V DC (will function at lower power at lower voltages listed above) |
Supply current | 500mA (maximum) |
Sub carrier frequency | 6.5MHz |
Dimension | 45 x 28 x 9mm |
Weight (transmitter only) | 22g |
Includes | Transmitter |
Frequencies:, 1258, *Notice: The use and operation of this product in the USA and other countries requires an amateur/ham radio license, and some countries may forbid its use entirely. It is the responsibility of the purchaser to ensure that the use of this product meets the requirements imposed by your government’s rules and regulations for RF devices. Do not purchase this product if you are unsure of the government requirements or are not able to comply with them. ReadyMadeRC cannot be held responsible for your actions if you purchase and/or use this product in violation of your government's regulations.,
WE'VE OPENED UP A WHOLE NEW FREQUENCY FOR LEGAL USE ...ReadyMadeRC
400MW 1300MHZ TRANSMITTER - NEW CUSTOM READYMADERC INTL VERSION
Weight with case and antenna | 3.2oz. |
Weight with bare module and antenna | 1.7 oz. |
CH4 | 1080MHZ |
CH5 | 1120MHZ |
CH6 | 1160MHZ |
CH7 | 1200MHZ |
CH8 | 1240MHZ |
CH9 | 1280MHZ |
CHH | 1320MHZ |
CHC | 1360MHZ |
CHd | 1258MHZ |
Frequencies:, *Notice: The use and operation of this product in the USA and other countries requires an amateur/ham radio license, and some countries may forbid its use entirely. It is the responsibility of the purchaser to ensure that the use of this product meets the requirements imposed by your government’s rules and regulations for RF devices. Do not purchase this product if you are unsure of the government requirements or are not able to comply with them. ReadyMadeRC cannot be held responsible for your actions if you purchase and/or use this product in violation of your government's regulations.,
WE'VE OPENED UP A WHOLE NEW FREQUENCY FOR LEGAL USE ...ReadyMadeRC
RMRC - 1.3GHZ 150MW TRANSMITTER - US VERSION
CH1 | 1258 MHz |
CH2 | 1280 MHz |
Power requirements | 12V, 200mA |
Weight | 22g (transmitter and antenna, no cables) |
Frequencies:, , NOTE: THESE TRANSMITTERS MAY ONLY WORK PROPERLY WITH THE STOCK ANTENNA. The transmitters are tuned at the factory using these antennas, and non-stock antennas may change the feedback the transmitter receives, which may cause the transmitter to operate on the incorrect frequency. In testing the power output of these units vary from about 75mW to 160mW from unit to unit., Notice: The use and operation of this product in the USA and other countries may require an amateur/ham radio license, and some countries may forbid its use entirely. It is the responsibility of the purchaser to ensure that the use of this product meets the requirements imposed by your government’s rules and regulations for RF devices. Do not purchase this product if you are unsure of the government requirements or are not able to comply with them. ReadyMadeRC cannot be held responsible for your actions if you purchase and/or use this product in violation of your government's regulations.,
Now includes the original 1280MHz, along with the new 1258MHz ...ReadyMadeRC
RMRC - 900MHZ 200MW TRANSMITTER - INTL VERSION
CH1 | 910 MHz (Only channel for units shipped to USA or Canada) |
CH2 | 980 MHz |
CH3 | 1010 MHz |
CH4 | 1040 MHz |
Power requirements | 12V, 200mA |
Frequencies:, , NOTE: THESE TRANSMITTERS MAY ONLY WORK PROPERLY WITH THE STOCK ANTENNA. The transmitters are tuned at the factory using these antennas, and non-stock antennas may change the feedback the transmitter receives, which may cause the transmitter to operate on the incorrect frequency.,
INTERNATIONAL VERSION, CANNOT SHIP TO A US ADDRESS UNDER ANY ...ReadyMadeRC
LOW PASS FILTER FOR 900MHZ ANTENNAS
Features | Low insertion loss |
ReadyMadeRC
VAS - 1.3 GHZ SKEW-PLANAR WHEEL ANTENNA (RHCP) - STRAIGHT
Gain | .92dbic |
Beam width | 360 degree doughnut |
Multipath rejection | 9db |
Polarization | RHCP |
ReadyMadeRC
JST FEMALE TO 3 JST MALE Y ADAPTER
,
Great for splitting a single battery power source to three ...ReadyMadeRC
LOW NOISE 3A REGULATOR (UBEC) W/NOISE REDUCTION
Output | 5v/3A or 6v/3A (Selectable via jumper) |
Noise | <50mVp-p(@2A/12v) |
Input | 5.5v-23v (2-5S Lipo pack, 5-15cells NiMh) |
Size | 41.6x16.6x7.0mm |
Weight | 7.5g |
ReadyMadeRC
REGULATOR BYPASS ADAPTER FOR IMMERSIONRC TRANSMITTERS
,
Want to use an ImmersionRC or FatShark transmitter with your ...ReadyMadeRC
AP117 TO READYMADERC FEMALE AUDIO/VIDEO ADAPTER
Includes | 1 adapter cable |
ReadyMadeRC
COMPACT 3 WIRE CAMERA TO MINI TRANSMITTER CABLE WITH JST
,
A great way to make a super-compact camera/transmitter setup. Includes ...