BevRC
FRSKY 5DB UPDATE ANTENNA
frsky Tx module to enlarge the control range." />
,
For frsky Tx module to enlarge the control range.BevRC
FRSKY D8R-XP TELEMETRY RECEIVER WITH CPPM PORT
FrSKY ACCST technology is proven, approved by many model associations, ..." />
| Operating voltage | 3.0~16V(HV Version) |
| Power consumption | 30mA |
| Resolution | 3072 |
| Latency | 22ms |
| Range | 1.5km-2.5km |
| Dimensions | 56 x 25 x 20 mm |
| Weight | 12.2g |
Features:, Advanced Continuous Channel Shifting Technology (ACCSTis our advanced tecnology it shifts channel hundred times per second and there is no signal conflicts and interruptions) robust frequency agility., Receiver Specification:, Number of channels: 8,
FrSKY ACCST technology is proven, approved by many model associations, ...BevRC
FRSKY FIRMWARE UPDATER TOOL
Frsky products." />
,
Used for the firmware update of Frsky products.BevRC
FRSKY V8FR-II RX
FrSKY ACCST technology is proven, approved by many model associations, ..." />
| Operating voltage | 3.0~16V(HV Version) |
| Power consumption | 30mA |
| Resolution | 3072 |
| Latency | 22ms |
| Range | 1.5km-2.5km |
| Dimensions | 44 x 24 x 14 mm |
| Weight | 9.3g |
Features:, Advanced Continuous Channel Shifting Technology (ACCSTis our advanced tecnology it shifts channel hundred times per second and there is no signal conflicts and interruptions) robust frequency agility., Receiver Specification:, Number of channels: 8,
FrSKY ACCST technology is proven, approved by many model associations, ...BevRC
FRSKY TFR8SB- COMPATIBLE WITH FUTABA FAAST RADIO WITH SBUS AND RSSI PORT
| FASST 2.4GHz Air Systems (7CH Mode/Multi Mode) | 6EX, 7C, TM-7, TM-8, T8FG, T10C, TM-10, T10CG, T12Z, T12FG, TM-14, T14MZ, etc |
| Model | TFR8SB (8CH FASST compatible receiver with RSSI & SB ports) |
| Dimension | 44.5*27.5*17mm |
| Operating Voltage Range | 3.5~10V |
| Operating Temperature Range | -10℃~80℃ |
| Mode A | RED LED blinks |
| Mode B | GREEN LED blinks |
:11.5g, :, 14ms (FS – Normal Speed Mode), Note: Be sure that when using battery or regulated output from ESC, the capacity must meet the usage conditions of servos., Use native failsafe position preset on the transmitter side:, If not disabling failsafe on the transmitter side, TFR8SB will use native failsafe position preset on the transmitter side., Set failsafe on TFR8SB side:, TFR8SB supports failsafe function for all channels. Follow the steps below to set failsafe on TFR8SB:, 1) Bind the receiver first, and disable failsafe on the transmitter side;, Note: HS mode is only applied for high-speed digital servos. Other servos should select FS mode, otherwise servos will get hot or even burn out., Note: Do not perform linking procedure while motor’s main wire is connected or engine is operating, otherwise damage may occur. After linking is completed, recycle the receiver power and check if the receiver is really under control by linked transmitter.,
It's a good choice for your multi-rotor with Naza or ...BevRC
FRSKY TEMPERATURE SENSOR
FrSky TEMS-01 Telemetry Temperature Sensor (for use with FrSky Telemetry ..." />
Measurement Range:, -20~250 degrees Celsius/ -4~482 degrees Fahrenheit, Accuracy:, 1 degree Celsius/ 1 degree Fahrenheit, Installation:, Use zip ties to hold the temperature sensor tightly against the accessory that requires temperature reading.,
FrSky TEMS-01 Telemetry Temperature Sensor (for use with FrSky Telemetry ...BevRC
FRSKY VARIMETRE SENSOR
FrSky FVAS-01 Telemetry Variometer Sensor (for use with FrSky Telemetry ..." />
| Measurement Range of Altitude | 0~9000m |
Accuracy:1m, Installation:, Use double-sided tape to install the variometer sensor on any appropriate surface of the airframe., *Note:, Wind will affect the altitude reading.,
FrSky FVAS-01 Telemetry Variometer Sensor (for use with FrSky Telemetry ...HiModel
FRSKY 40A AMPERE SENSOR FAS-40
FrSky Sensor Hub or ..." />
| Model | FAS-140 |
| Dimension | 31.5x24.5x5mm |
| Weight | 9.7g |
| Measurement range | 0~40A |
| Maximum safe current | 40A |
| Sensor current consumption | 20mA |
| Update Rate | ≥1Hz |
, , , , , , Specifications:, , , , , , , , , , , , ,
Features: FAS-40 can be connected to FrSky Sensor Hub or ...HiModel
FRSKY TWO-WAY 2.4G FUTABA COMPATIBLE RADIO SYSTEM TELEMETRY DFT/D8R-II PLUS
FrSky provides an ..." />
| Model | DFT |
| Operating Voltage Range | 6.0V-13.0V |
| Operating Current | 50mA |
| Output Power | 60mW |
| Resolution | 11bit (3072) |
| Futaba | 3PM, 3PK, 7U, 8U, 8J, 9C, 9Z, 10C, FN series, T10C, FC-18, FC-28. |
| Hitec | Optic 6, Eclipse 7, Prism 7. |
| WFLY | WFT09, WFT08. |
| Model | D8R-II Plus |
| Weight | 16.2g |
| Dimension | 54*27*17mm |
| Operating Voltage Range | 4.0V-7.2V |
| Operating Current | 100mA |
| Specified Range | 1.5km (Ground Range) |
| Resolution | 11bit (3072) |
| Latency | 22ms |
| Number of Channels | 8CH |
| Analog voltage | 0~3.3V |
, , , , , , Specifications:, , , , , , , , , , , Transmitter module specifications:, Compatible with the following transmitters:, Receiver specifications:, , ,
Features: The Two-way Radio System developed by FrSky provides an ...2 Reviews
HiModel
FRSKY TWO-WAY 2.4G DHT MODULE - TOGGLE SWITCH VERSION
| Operating Voltage Range | 6.0V-13.0V |
| Operating Current | 50mA |
| Output Power | 60mW |
| Resolution | 3072 (>11bit) |
, , , , , , , , Features:, , , , , , , , , , , THIS IS THE NEW TOGGLE SWITCH VERSION DHT., 1.1 Compatibility:, Switch 1, , Switch 2, , Mode of DHT, , Compatibility, , OFF, , OFF, , Two-way Mode, , Two way telemetry receivers (D8R, D6FR), , OFF, , ON, , V8 Mode, , V8 receivers (V8FR-HV, V8R7-HV, V8R7-SP, V8R4), , 1.2 Specifications:, 2. Setup, 2.1 Installation process:, 1）Open the transmitter, find out Battery power supply line, PPM signal line, and GND., 2）Take the order and solder Battery power supply line, PPM signal line, and GND to DHT with 3 wires., (RED→V+; BLACK→GND; YELLOW→PPM), 3）Drill one hole on the transmitter to install the PCB with F/S button, GREEN/RED LED and two switches., 4）Connect the antenna connector at the port on transmitter board., 5）Drill a hole for antenna connector at suitable space on the transmitter (diameter 7mm is suitable)., 6）Fix the transmitter antenna on the connector .Turn the transmitter power on and check the power indicator LED, which is normally light RED., 2.2 Bind procedure, 1）Turn your transmitter on and switch it to PPM mode. Turn your transmitter off., 2） Turn your transmitter on while holding the F/S button on the transmitter module (Please make sure DHT is in its corresponding mode when working with V8 or two way telemetry receivers). Release it in a few seconds. The RED LED on the transmitter module will flash, indicating the transmitter is ready to bind the receiver., 3）Connect battery to the receiver while holding the F/S button on the receiver. The RED LED on the receiver will flash, indicating the binding process is completed., 4）Turn on the transmitter and re-connect battery to the receiver. The RED SOLID LED on the receiver will indicate the receiver is receiving commands from the transmitter., 5）After the above steps are completed, both the transmitter and the receiver are ready to be used., Notice: When working with two way telemetry receivers (D8R or D6FR), please kindly make sure that the battery ,
Features: THIS IS THE NEW TOGGLE SWITCH VERSION DHT. 1.1 ...1 Reviews
HiModel
FRSKY TWO-WAY 2.4G JR COMPATIBLE RADIO SYSTEM TELEMETRY DJT/D8R-II V2
FrSky provides an ..." />
| Model | DJT |
| Operating Voltage Range | 6.0V-13.0V |
| Operating Current | 50mA |
| Output Power | 60mW |
| Resolution | 11bit (3072) |
| Model | D8R |
| Weight | 16.2g |
| Dimension | 54*27*17mm |
| Operating Voltage Range | 4.0V-7.2V |
| Operating Current | 100mA |
| Specified Range | 1.5km (Ground Range) |
| Resolution | 11bit (3072) |
| Latency | 22ms |
| Number of Channels | 8CH |
| Analog voltage | 0~3.3V |
, , , , , , Specifications:, , , , , , , , , , , Transmitter module specifications:, Compatible with the following transmitters:, JR: 347/388/783/U8/PCM10/PCM10S/PCM10SX/, PCM10IIS/8103/J9303/MX-22/MX-24S/PX/9XII., Receiver specifications:, , ,
Features: The Two-way Radio System developed by FrSky provides an ...2 Reviews
GetFPV
FRSKY XJT 16CH RADIO TRANSMITTER MODULE - JR/GRAUPNER TYPE
| Operating Voltage Range | 6.0V-15.0V |
| Operating Current | 140mA (@6V), 80mA (@12V) |
| Output Power | ≤ 100mW |
Features:, Advanced Continuous Channel Shifting Technology (ACCST SYSTEM) achieves highly reliable link in interference rich environments., Compatibility:, V8 Series:, (Non-Telemetry receivers), D Series:, (Telemetry receivers), X Series:, (Telemetry receivers), LR Series:, (Long Range receivers), Compatible with the following transmitters:, JR:347, 388, 783, Specifications:,
Details The XJT telemetry transmitter module is compatible with the ...GetFPV
FRSKY DF 2.4GHZ COMBO PACK FOR FUTABA W/ MODULE & RX
FrSKY ACCST technology is proven, approved by many model ..." />
| Futaba | 3PM, 3PK, 7U, 8U, 9C, 10C, 9Z, FN-Series, T10C, FC-18, FC-28. |
| Hitec | Optic 6, Eclipse 7, Prism 7 |
| WFLY | WFT09, WFT-08 |
| Operating voltage | 3.5 - 10.0V |
| Power consumption | 100mA |
| Resolution | 3072 |
| Latency | 22ms |
| Analog voltage | 0~3.3V |
| Range | 1.5km-2.5km |
| Dimensions | 55 x 25 x 14 mm |
| Weight | 12.4g |
| Version | 2.0 |
| Operating voltage | 6.0V-13.0V (can handle 3S!) |
| Power consumption | 50mA |
| Resolution | 3072 (11bit) |
| Dimensions | 58.5x37.5x22mm |
| Version | 2.0 |
Features:, Advanced Continuous Channel Shifting Technology (ACCST is our advanced tecnology it shifts channel hundred times per second and there is no signal conflicts and interruptions) robust frequency agility., V8FT:, Receiver Specification:, Number of channels: 8, Module specification:, Output Power:: 60mW,
Details FrSKY ACCST technology is proven, approved by many model ...GetFPV
FRSKY FLVS-01 - LIPO VOLTAGE SENSOR AND DISPLAY
| Dimension | 45*21*7mm |
| Weight | 5.2g |
| Measurement range | 1S~6S (The first lipo voltage should be more than 3.55V) |
| Cell voltage display range | 0.20~4.20V |
| Voltage display resolution | 0.01V |
| Voltage detection precision | 0.03V |
| Current of the board | 15.5mA |
| Operating temperature range | -30℃~70℃ |
| Pixel | 128*64 with OLED display screen |
How to detect and display 1S~6S:,
Details This small lipo voltage sensor is the perfect display ...GetFPV
FRSKY DELTA 8 2.4GHZ 8CH MULTI-BRAND RECEIVER
FrSky's latest all in one receiver, compatible with 3 ..." />
| Operating Voltage Range | 3.0V-16V (HV Version) |
| Operating Current | 30mA |
| Specified Range | 1.5km-2.5km |
| Resolution | 3072 |
| Latency | 22ms |
| Number of Channels | 8CH |
| Dimensions | 49mm×24.5mm×15 mm |
| Weight | 9.3g |
Compatible with transmitters that use the following protocols:, Hitec A-FHSS,
Details FrSky's latest all in one receiver, compatible with 3 ...