Flying-Hobby
FUTABA SBD-1 S.BUS DECODER (16"/400MM)
Futaba SBD-1 S.Bus Decoder (16"/400mm) This is the Futaba SBD-1 ..." />
| Total Length | 16" (400mm) |
| Servo Lead Length | 3.1" (79mm) |
Features:, 16" (400mm) total length, with 3.1" (79mm) servo lead, Specifications:,
Futaba SBD-1 S.Bus Decoder (16"/400mm) This is the Futaba SBD-1 ...Flying-Hobby
FUTABA GY520 GYRO WITH S9257 SERVO
| Size | 0.82 x 0.82 x 0.43" (20.8 x 20.8 x 11mm) |
| Weight | 0.243 oz (6.9g) |
| Voltage Range | 3.8 - 6.0V DC |
| Control System | Advanced PID control |
| Current Draw | 40mA (without servo) |
| Sensor | MEMS vibrating structure gyro |
| Operating Temperature | 14°F - 113°F (-10°C - +45°C) |
| Sensor Rate Range | +/- 800° sec |
| Angular Velocity Range | +- 800 deg/sec |
Features:, Ultra small and light weight gyro contained in one unit-no separate sensor and control unit, Specifications:, Accessories:,
Utilizes a high speed advanced PID (Proportional-Integral-Derivative) control algorithm Latest ...Flying-Hobby
FUTABA GY520 MICRO GYRO
,
GY520 Gyro w/Heading Hold Introducing the smallest, lightest heading hold ...Flying-Hobby
RJX NECK STRAP ADAPTORS( FOR FUTABA/JR 9 AND LESS 9 CHANNEL) RED
Futaba/JR 9 and less 9 channel Red" />
,
For Futaba/JR 9 and less 9 channel RedFlying-Hobby
BMR-6CH-72MHZ (FUTABA)RECEIVER
| Current Drain | 48 mA +/- 550 mA |
| Operating Voltage | 3.6~7.2V |
| Modulation | FM(PPM) |
| Sensitivity | 5uV |
| Range(on Ground) | 250m / 800’ ft |
| Size(W x L x H)? | 20.3 x 30.5 x 9.8 mm |
| Ant length | 100cm / 40” in |
| Weight Vertical | 8.6g |
Flying-Hobby
RJX NECK STRAP ADAPTORS( FOR FUTABA/JR 9 AND LESS 9 CHANNEL) BLACK
Futaba/JR 9 and less 9 channel Black" />
,
For Futaba/JR 9 and less 9 channel BlackFlying-Hobby
CHARGE ADAPTER SET (JST JR FUTABA)
FUTABA RADIO 3. JR RADIO 4. T Connector 5. ..." />
| Use For | 1. JST |
Flying-Hobby
FUTABA 10CHG 10-CHANNEL 2.4GHZ WITH R6014HS RECEIVER (MODE 2)
This package includes:, , Enhanced Features:, Slider Switches, 9 Factory-Defined Mixes: Elevator-Flap; Ailvator (for dual elevator servos); Throttle-Needle; Aileron Differential; Flaperon; V-Tail; Elevon; Snap Roll; and Air Brake w/elevator delay, 8 Factory-Defined Mixes: Hover-Throttle; Hover-Pitch; Throttle-Needle; Governor; Offset; Revo (5-pt.); Delay; and Throttle Mix (ail/ele/rdr), 12 Factory-Defined Mixes: Butterfly-Elevator; Elevator-Flap; Chamber Mix (w/ail/ele/rdr adj.); Aileron-Flap; Aileron-Rudder; Flaperon; V-Tail; Flap Trim; Butterfly w/spoiler adj; and 4-point Offset (w/camber adj. for basic/launch/thermal/speed),
********can not ship to Turkey and Belgium( as the custom ...Flying-Hobby
FUTABA 10CHG 10-CHANNEL 2.4GHZ WITH R6014HS RECEIVER (MODE 1)
This package includes:, , Enhanced Features:, Slider Switches, 9 Factory-Defined Mixes: Elevator-Flap; Ailvator (for dual elevator servos); Throttle-Needle; Aileron Differential; Flaperon; V-Tail; Elevon; Snap Roll; and Air Brake w/elevator delay, 8 Factory-Defined Mixes: Hover-Throttle; Hover-Pitch; Throttle-Needle; Governor; Offset; Revo (5-pt.); Delay; and Throttle Mix (ail/ele/rdr), 12 Factory-Defined Mixes: Butterfly-Elevator; Elevator-Flap; Chamber Mix (w/ail/ele/rdr adj.); Aileron-Flap; Aileron-Rudder; Flaperon; V-Tail; Flap Trim; Butterfly w/spoiler adj; and 4-point Offset (w/camber adj. for basic/launch/thermal/speed),
********can not ship to Turkey and Belgium( as the custom ...Flying-Hobby
TITAN E325SE FUTABA 2.4G EXTREME READY TO FLY
| Market Price | USD$930 |
| Combo Price | USD$769 |
| Save Total | USD$161 |
| Full Length of fuselage | 25.75" |
| Full width of fuselage | 4.72" |
| Total height | 8.3" |
| Main rotor dia | 28.54" |
| Tail rotor dia | 6.14" |
| Full equipped weight | 30.60 oz. |
| Motor | No.2382 OBL 29-37-10H |
| ESC | No.8041-H BLC-40 |
| Blades | Wood Blades |
Combo Included:, 1.Titan E325 SE Kit, Specification:, , Gear ratio: 1 : 11.5 : 4.4, Features:, , Content:, , Accessories Needed:,
Titan Brushless Motor Titan 40A ESC Hitec HS65 MG Hitec ...Flying-Hobby
TITAN E325SE FUTABA 2.4G SUPER READY TO FLY
| Market Price | USD$996 |
| Combo Price | USD$829 |
| Save Total | USD$167 |
| Full Length of fuselage | 25.75" |
| Full width of fuselage | 4.72" |
| Total height | 8.3" |
| Main rotor dia | 28.54" |
| Tail rotor dia | 6.14" |
| Full equipped weight | 30.60 oz. |
| Motor | No.2382 OBL 29-37-10H |
| ESC | No.8041-H BLC-40 |
| Blades | Wood Blades |
Combo Included:, 1.Titan E325 SE Kit, Specification:, , Gear ratio: 1 : 11.5 : 4.4, Features:, , Content:, , Accessories Needed:,
Titan Brushless Motor Titan 40A ESC Hitec HS65 MG Hitec ...ReadyMadeRC
PHOENIX FUTABA SQUARE MICRO ADAPTER
Futaba transmitters to Phoenix Flight Sim." />
,
Adapter for most Futaba transmitters to Phoenix Flight Sim.BevRC
FUTABA SQUARE-TYPE TRAINER CONNECTOR
| http | //users.belgacom.net/TX2TX/tx2tx/english/tx2txgb3.htm |
Check the definition of the pin s here:,
You can use it to make the cable yourself, the ...BevRC
FRSKY TFRSP- FUTABA FASST COMPATIBLE WITH SPPM AND RSSI PORT
| FASST 2.4G Air Systems (7CH Mode/Multi Mode) | 6EX, 7C, TM-7, TM-8, T8FG, T10C, TM-10, T10CG, T12Z, T12FG, TM-14, T14MZ, etc. |
| Number of Channels | up to 10 channels (CPPM for CH1~CH9, servo signal for CH5~CH10) |
| Operating Voltage Range | 3.5V~10V |
| Operating Temperature Range | -10℃~60℃ |
| Dimension | 53mm*30mm*11mm |
| Weight | 13.5g |
| Note | Increased duty means good signal reception, and vice verse. |
1.1 Compatibility:, 1.2 Specifications:, Warning: Servos are not to be plugged into Channel CPPM and Channel RSSI, otherwise servos will get hot or may burn out., 2.1 Bind procedure:, Turn on the transmitter, connect the battery to the receiver while pressing receiver’s F/S button. After the RED LED is off and GREEN LED is solid, the binding process is completed and the receiver is operating normally., 2.2 Setting failsafe:, TFRSP supports failsafe function for all channels. Follow the steps below to set failsafe:, 1) Bind the receiver first, and disable failsafe on the transmitter side;, Warning: Some transmitter manufacturers use a failsafe method that can interfere with that used by FrSky. Be sure to disable any transmitter failsafe settings before setting FrSky failsafe positions. Unusual jitter may result otherwise., 2.3 LED status:, , Please find the how-to guide with the file named “Set up FrSky as a wireless trainer system” via the following link:, www.frsky-rc.com/download.asp?id=23,
Can be used with YS-X4 through one cable, using the ...