DPCAV
RF MODULE HEAT SINK
| Material | Aluminum |
| Size | 0.91 x 0.91 x 0.35 inches |
| Weight | 6 grams |
| Installation | Thermal rated adhesive tape (included) |
| Data Sheet | Click Me! |
Specifications:, ,
This compact aluminum heatsink is a perfect addition to your ...DPCAV
5VDC 5A VOLTAGE REGULATOR (BEC), SWITCH-MODE TYPE
| White | Not installed (N/A) |
| Red | +5VDC Output |
| Black | Ground |
| Specifications | Input |
| Output | 5VDC, 5A maximum |
| Technology | Switch-Mode Regulator |
| Size | 1.5 x 0.8 x 0.5 inch (38x21x13mm) |
| Weight | 9 grams |
| Origin | Made in China by AEO Tech |
The DC input has 2-inch bare leads (Red wire = BAT+). The 5-inch long output cable has a 3-pin servo style connector, wired as follows:, ,
This step-down Voltage Regulator accepts 6-23 VDC on its input ...DPCAV
ADJUSTABLE VOLTAGE REGULATOR, 1-35V SEPIC TYPE
| IN+ | Battery/Power In + |
| IN- | Battery Ground |
| OUT+ | Regulated Voltage |
| OUT- | Common Ground |
| Specifications | Input |
| Output | 1.2VDC-30VDC 2A / 10W maximum |
| Switching Frequency | 60KHz typical |
| Output Ripple | 150mV at 10W loads typical |
| Technology | Switch-Mode SEPIC Regulator |
| Voltage Adjust | Screwdriver Access |
| Size | 1.9 x 0.9 x 0.5 inch (49x22x12mm) |
| Weight | 15 grams |
The circuit board has four pads (soldering required) that are labeled as follows:, ,
This Voltage Regulator has an adjustable 1.2VDC to 30VDC output. ...DPCAV
BATTERY ALARM FOR 2-4 CELL (2S-4S) LIPO
| Good voltage (above 3.85V/cell) | Solid ON blue LED. |
| Normal voltage (3.3V-3.85V) | Slow Flash white LED. |
| Low voltage (under 3.3V/cell) | Fast Flash white LED with beep. |
| ● Voltage | 6-18V VDC (2-cell to 4-cell LiPO, auto detect). |
| ● Cable | 18 inches (45 cm), pre-wired with 4S balancing connector. |
| ● Weight | 5 grams. |
| ● Size | 0.8 x 0.5 x 0.4 inches (19 x 13 x 10 mm). |
LED Alarm Thresholds are as follows:, , Specifications:, ,
Micro-sized LiPO (Lithium Polymer) battery alarm. Works with 2S-4S LiPO ...DPCAV
PIGTAIL CABLES (BALANCE PORT)
,
Pigtail cables for LiPO battery balancing or general electronic applications. ...DPCAV
5VDC POWER ADAPTER, 600MA (EUROPEAN)
| Note | This AC wall adapter is compatible with our |
DPCAV
GOPROHD HERO/HERO2 CAMERA CABLE FOR SKYRF / BOSCAM / FOXTECH TRANSMITTERS
| Yellow | Not Used |
| Orange | Audio |
| Red | Video |
| Brown | Ground |
| IMPORTANT | This cable is NOT compatible with Immersion-RC or Fat-Shark transmitters. |
The wire colors are as follows (be sure to check your old cable and confirm the wire colors/locations are the same):, ,
This lightweight video cable is used to connect the GoPro ...DPCAV
GOPROHD HERO/HERO2 CAMERA CABLE FOR TX-5G8-600
| Yellow | Audio Right |
| Orange | Audio Left |
| Red | Video |
| Brown | Ground |
The wire color codes are as follows:, ,
This lightweight A/V (audio/video) cable is used to connect the ...DPCAV
POWER SUPPLY FILTER, L-C TYPE
This filter is used to reduce ripple noise and similar power supply nuisances. When used with power sources that have RFI/EMI noise problems we recommend that you also add Toroids filters on all the affected wires / cables. We offer popular sized Toroid (Ferrite) core filters that are ideal for RFI/EMI problems:Click Me!, Design Update: Beginning with September 2011 production, all PSF-001 filters are compatible with up to 5S LiPo batteries. Earlier production was limited to 3S applications. If you need to identify which voltage rating you have then check the printed voltage on the large 1000uF cap (capacitor); The older design used 16V caps where as the new design we now sell uses 25V rated caps., Note: Installations with severe power supply noise may not be fully cured with this filter. In such cases a shared battery should be avoided., Installation requires soldering in-series with the noisy power supply, as follows:, , Instructions:, Click Me!,
This compact supply filter helps clean up dirty DC power ...DPCAV
1280MHZ PATCH ANTENNA, +8DBI FACTORY TUNED
| < 1.5 | 1 avg. |
A data sheet is not available, but it this antenna is identical (except for frequency and coax length) to the L-Com RE1208P antenna:Click Me!,
This compact patch antenna has been factory tuned for use ...DPCAV
LOW PASS ANTENNA FILTER FOR 1.2GHZ - 1.3GHZ TX
Features / Specifications:,
This Low Pass Filter is designed to attenuate the radiated ...DPCAV
900MHZ ANTENNA, SWIVEL SMA
| Frequency | 900-980 MHz |
| RF Gain | +3dBi |
| Type | Omni, coaxial sleeve half-wave dipole |
| Length | 8.4 inches (213mm) |
| Weight | 32 grams |
| Data Sheet | Not Available. |
DPCAV
1280MHZ PATCH ANTENNA, +8DBI CUSTOM TUNED
| < 1.5 | 1 avg. |
| Reference Data Sheet to the unmodified antenna | Click Me! |
| Note | We also offer a factory tuned 1280MHz patch antenna |