DPCAV
8-PIN PCB CONNECTOR FOR EB-85A & FV-M8 GPS
| Data Sheet | Click Me! |
DPCAV
2.4GHZ YAGI ANTENNA WITH SMA, +13DBI
| Frequency | 2400 to 2483 MHz |
| Gain | ~13dBi |
| 13 Elements | 11 directors, 1 reflector, 1 driven |
| Polarization | linear |
| Impedance | 50 ohms |
| Maximum power | 50W |
| Connector | N Female with SMA plug adapter |
| Antenna length | 19.7 inches (500mm) |
| U-bolt diameter | 2.4 inches (60mm) |
| Weight | 11 ounces (300 grams) |
Specifications / Features:, , Horizontal beam width: 45, Vertical beam width: 40,
2.4GHz Yagi Antenna with SMA Plug. Directional high gain design, ...DPCAV
ELOGGER OSD RCA CONNECTOR ADAPTER, 12 INCH
,
This RCA plug equipped video cable is used with the ...DPCAV
ELOGGER OSD RCA CONNECTOR ADAPTER, 20 INCH
,
This 20 inch (50 cm) long RCA equipped video cable ...DPCAV
ELOGGER RPM SENSOR WITH MAGNETS
| eLogger Instruction Manual (includes RPM Sensor) | Click Me! |
DPCAV
RSSI BUFFER FOR OSD PRO
| Operating Voltage | 5VDC (powered by EagleTree eLogger). |
| Current Draw | 2 milliamps. |
| RSSI Voltage Range | 0 - 4.0 VDC. |
| RSSI Input ohms | > 1 megohms (DC). |
| Input Impedance | 330K ohms (AC). |
| Size/Weight | 0.45 x 0.73 inches (11 x 19 mm), 2 grams. |
| (note | video is courtesy of R. Bill, a very satisfied user.) |
Specifications / Features:, Installation Instructions:, Click Me!, Cable Pin-Out Information:, Click Me!, Installation Video:, Click Me!,
The RSSI Buffer is a tiny-sized accessory that is used ...DPCAV
ELOGGER V4 WITH CONNECTORS, 100 AMP SENSOR
| Instruction Manual | Click Me! |
| Manufacturer's Web Site | Click Me! |
Specifications:, Logs battery current to +/- 100 Amps, .02A resolution.,
Whether you’re into robotics, R/C models or Ham radio ATV, ...DPCAV
5.8GHZ SKEW-PLANAR WHEEL ANTENNA, RHCP
| Center Frequency | 5.8GHz |
| RF Bandwidth | 120MHz |
| Gain, 3-lobe | ~0.9dBiC |
| Beamwidth | 360° omni |
| Polarization | RHCP |
| Multipath rejection | ~9db typical |
| RF connector | SMA Plug |
| Height | 1.2 inch |
| Width | 1.2 inch |
| Weight | 4.5g |
| REFERENCE PLOTS | ANTENNA RF PATTERNS |
Manufacture:, Aerial Video Systems, Important: To ensure RF performance do NOT add paint or coat the element lobes (leave the factory applied finish as-is). The elements should not be allowed to rest against any structures. Do not bend or deform the elements., NOTE: Some installations will need a coax extension cable to ensure the antenna is away from nearby surfaces.,
The 5.8GHz Skew-Planar Wheel antenna is circularly polarized (RHCP) and ...DPCAV
5.8GHZ CLOVERLEAF ANTENNA, RHCP
| Center Frequency | 5.8GHz |
| RF Bandwidth | 120MHz |
| Gain, 3-lobe | ~1.2dBiC |
| Beamwidth | 360° omni |
| Polarization | RHCP |
| RF connector | SMA Plug |
| Height | 1.2 inch |
| Width | 1.2 inch |
| Weight | 4.4g |
| REFERENCE PLOTS | ANTENNA RF PATTERNS |
Manufacture:, Aerial Video Systems, Important: To ensure RF performance do NOT add paint or coat the element lobes (leave the factory applied finish as-is). The elements should not be allowed to rest against any structures. Do not bend or deform the elements., NOTE: Some FPV model installations may need an extension to ensure the antenna is away from nearby surfaces.,
The 5.8GHz Cloverleaf antenna is circularly polarized (RHCP) and designed ...DPCAV
5.8GHZ BLUEBEAM ANTENNA SYSTEM, RHCP
| Cloverleaf (3-lobe) for transmitter | Click Me! |
| Skew Planar Wheel (4-lobe) for receiver | Click Me! |
| Center Frequency | 5.8GHz |
| RF Bandwidth | 120MHz |
| Gain, 3-lobe | ~1.2dBiC |
| Gain, 4-lobe | ~0.9dBiC |
| Beamwidth | 360° omni |
| Polarization | RHCP |
| Multipath rejection | ~9db typical |
| RF connector | SMA Plug |
| Height | 1.2 inch |
| Width | 1.2 inch |
| Weight | 4.4g each |
| REFERENCE PLOTS | ANTENNA RF PATTERNS |
This 5.8GHz antenna system contains TWO antennas:, One for the transmitter and one for the receiver., If you are looking for replacements then we also sell them individually, as follows:, , Manufacture:, Aerial Video Systems, Important: To ensure RF performance do NOT add paint or coat the element lobes (leave the factory applied finish as-is). The elements should not be allowed to rest against any structures. Do not bend or deform the elements., NOTE: We offer very low-loss extension cables that are specifically designed for the BlueBeam antenna system. Some FPV model installations may need an extension to ensure the antenna is away from nearby surfaces.,
The 5.8GHz Bluebeam antenna system is circularly polarized (RHCP) and ...DPCAV
5.8GHZ ANTENNA WITH SWIVEL SMA, +5DBI DIPOLE
| Data Sheet | Not available |
DPCAV
CABLE FOR DPC-420A/480A/540A CAMERA
| Note | For hardwired use, just cut the cable. That will result in a 16 inch long "pigtail." |
DPCAV
FPV POD PAN & TILT KIT FOR SKYWALKER
| Assembly manual | Click Me! |
| Manufacture's site | ReadyMadeRC |
The kit comes with two R/C servos, so it is a fantastic value. The provided camera mounting plate will fit many popular CCD cameras including:, DPC-171, DPC-520S, KX131, KX171, KX191 and others. An optional back plate is available that converts this kit for use with the DPC-420A, DPC-480A, and DPC-540A OSD cameras (, The kit includes:, Laser cut plywood components, You'll need to supply:, Double sided servo tape, Note: The video transmitter, camera, and battery are not included. They are shown in the photos for reference only.,
This FPV Pod video camera pan/tilt kit is specifically designed ...DPCAV
RP-SMA EXTENSION CABLE, RG-400 COAX
SPECIFICATIONS:,
Low loss RG-400 coaxial extension cable with high quality factory ...