HiModel
FRSKY TWO-WAY 2.4G 4-CHANNEL RECEIVER D4R-II
| Dimension | 40*22.5*6mm |
| Weight | 5.8g / 5g (naked) |
| Operating Voltage Range | 3.5V-10.0V |
| Operating Current | 60mA |
| Operating Range | Full Range (>1.5km) |
| Resolution | 3072 (>11bit) |
| Compatible with FrSky two way telemetry modules | DFT, DJT, DHT, DHT-U |
, , , , , , Specifications:, , , , , , , , , , , Compatibility, , ,
Features: Features 1) Firmware upgradeable; 2) One external analog telemetry ...HiModel
FRSKY RECEIVER UPGRADE LITE
FrSky receiver upgrade lite Includes/Requires: Includes: 1 x receiver ..." />
| Refer to http | //www.frsky-rc.com/download.asp?id=22. for instructions and software etc. |
, , , , , , Specifications:, , , , , , , , , , , , ,
Features: FrSky receiver upgrade lite Includes/Requires: Includes: 1 x receiver ...HiModel
FRSKY SENSOR HUB FSH-01
FrSky Sensor Hub (FSH-01) FrSky Sensor Hub is recommended ..." />
| Dimension | 37*30*8mm |
| Operating Voltage Range | 4~10V |
| Operating Temperature Range | -20~80℃ |
| Feature | Firmware upgradable |
, , , , , , Specifications:, , , , , , , , , , , Weight:, Installation:, It is recommended to take the length of all sensors’ wires into consideration before mounting, and use double-sided tape to install FrSky sensor hub at an appropriate place in the model., , ,
Features: FrSky Sensor Hub (FSH-01) FrSky Sensor Hub is recommended ...HiModel
FRSKY 2.4G 4-CHANNEL MICRO RECEIVERS V8R4-II
| Dimensions | 36*17.5*8mm |
| Weight | 3.5g / 2.7g (naked) |
| Operating Voltage Range | 3.0~16.0V (HV version) |
| Operating Current | 30mA |
, , , , , , Specifications:, , , , , , , , , , , FrSky modules, , How to put V8R4-II into binding mode respectively, , V8FT, V8JT, V8HT, , V8_Mode (Non-telemetry), , Connect battery to V8R4-II while holding the F/S button on V8R4-II, , DFT, DJT, DHT, DHT-U in V8_Mode, , (Switch 1 OFF and Switch 2 ON), , DFT, DJT, DHT, DHT-U in D_Mode, , (Switch 1 OFF and Switch 2 OFF), , D_Mode (Telemetry), , Connect Ch1 & Ch2 signal pins of V8R4-II by provided jumper and then, , connect battery to V8R4-II directly (no need to hold the F/S button on V8R4-II), , , ,
Features: THIS IS THE UPGRADED VERSION OVER V8R4. New feature ...4 Reviews
HiModel
FRSKY 2.4G 3/16 CHANNEL FUTABA FASST COMPATIBLE RECEIVER W/SB PORT TFR4SB
| Model | TFR4SB (3/16 channel FASST compatible receiver with SB port) |
| Dimension | 41*24*6mm |
| Weight | 6.0g/4.2g (naked) |
| Operating Voltage Range | 3.5 ~ 10V |
| Operating Temperature Range | -10℃~ 80℃ |
| Servo Frame Rate | 14ms (FS - Normal Speed Mode) |
| FASST 2.4G Air Systems (7CH Mode/Multi Mode) | 6EX, 7C, TM-7, TM-8, T8FG, T10C, TM-10, T10CG, T12Z, T12FG, |
| FASST 2.4G Surface Systems (C1 Mode) | 3PK, 4PK, etc. |
, , , , , , Specifications:, , , , , , , , , , , Specifications:, 7ms (HS - High Speed Mode), Compatible systems, TM-14, T14MZ, etc., Compatible servos at SB port, Futaba S.BUS servos, FrSky servo D12MB, , ,
Features: Features: 1) Compatible with FASST 2.4G: Air Systems (7CH ...HiModel
FRSKY SERVO CHANNEL CHANGER FOR SBUS SERVOS & SBUS TO PWM DECODER
| Dimensions | 48 x 67 x 22mm |
| Weight | 6.7g |
| Operating Temperature Range | -10-45 ℃ |
| Operating Voltage | 3-16V |
| Compatibility for Servo Connection Port | FrSky SBUS & CPPM compatible servo, Futaba S.BUS servo, FrSky SBUS Decoder |
, , , , , , Specifications:, , , , , , , , , , , FrSky Servo Channel Changer for SBUS Servos & SBUS to PWM Decoder, , ,
Features: This product is a tool for setting the channel ...HiModel
FRSKY 2.4G ACCST/S-FHSS/A-FHSS COMPATIBLE 8-CHANNEL RECEIVER DELTA-8 (FUTABA, HITEC COMPATIBLE)
| Dimensions | 36*17.5*8mm |
| Weight | 3.5g / 2.7g (naked) |
| Operating Voltage Range | 3.0~16.0V (HV version) |
| Operating Current | 30mA |
, , , , , , Specifications:, , , , , , , , , , , FrSky modules, , How to put V8R4-II into binding mode respectively, , V8FT, V8JT, V8HT, , V8_Mode (Non-telemetry), , Connect battery to V8R4-II while holding the F/S button on V8R4-II, , DFT, DJT, DHT, DHT-U in V8_Mode, , (Switch 1 OFF and Switch 2 ON), , DFT, DJT, DHT, DHT-U in D_Mode, , (Switch 1 OFF and Switch 2 OFF), , D_Mode (Telemetry), , Connect Ch1 & Ch2 signal pins of V8R4-II by provided jumper and then, , connect battery to V8R4-II directly (no need to hold the F/S button on V8R4-II), , , ,
Features: THIS IS THE UPGRADED VERSION OVER V8R4. New feature ...HobbyKing
FRSKY DELTA 8 2.4GHZ 8CH MULTI-BRAND RECEIVER D8/V8 FUTABA S-FHSS/FHSS HITEC AFHSS COMPATIBLE
FrSky Delta 8 receiver is a multi-brand 2.4GHz receiver ..." />
| This unit works with the following systems | FrSky D8 |
| Operating Current | 30mA |
| Specified Range | 1.5km-2.5km |
| Resolution | 3072 |
| Latency | 22ms |
| Number of Channels | 8CH |
| Dimensions | 49mm×24.5mm×15mm |
| Weight | 9.3g |
Receiver Specifications:, Operating Voltage Range:, 3.0V-16V (HV Version),
The FrSky Delta 8 receiver is a multi-brand 2.4GHz receiver ...5 Reviews
HobbyKing
FRSKY 2.4GHZ ACCST TARANIS X9D DIGITAL TELEMETRY RADIO SYSTEM (MODE 2)
Frsky TARANIS sets a ..." />
| • Processor | STM32 ARM Cortex M3 60MHz |
| Model name | Taranis X9D |
| Number of Channels | up to 16 |
| Operating Temperature | -10~60C |
| Backlit LCD Screen | 212*64 Monochrome |
Features:, • RSSI alarms (warns you of reception problems before it becomes an accident), Specifications:, Operating Voltage Range:, 6-15v (2s, 3s Lipos are acceptable), Operating Current:, 260mA maximum (both RF module and backlit are on), Model Memories:, 60 (expandable by SD card), Compatibility:, FrSky X series, D series and V8-II series receivers, stick mode:, Mode 2 (Left hand throttle), Includes:, Taranis X9D ACCST 2.4GHz Transmitter (Mode 2 version),
When it comes to possibilities the Frsky TARANIS sets a ...5 Reviews
HobbyKing
FRSKY 2.4GHZ ACCST TARANIS X9D DIGITAL TELEMETRY RADIO SYSTEM (MODE 1)
Frsky TARANIS sets a ..." />
| • Processor | STM32 ARM Cortex M3 60MHz |
| Model name | Taranis X9D |
| Number of Channels | up to 16 |
| Operating Temperature | -10~60C |
| Backlit LCD Screen | 212*64 Monochrome |
| stick mode | Mode 1 |
Features:, • RSSI alarms (warns you of reception problems before it becomes an accident), :, Operating Voltage Range:, 6-15v (2s, 3s Lipos are acceptable), Operating Current:, 260mA maximum (both RF module and backlit are on), Model Memories:, 60 (expandable by SD card), Compatibility:, FrSky X series, D series and V8-II series receivers, Includes:, Taranis X9D ACCST 2.4GHz Transmitter (Mode 1 version),
When it comes to possibilities the Frsky TARANIS sets a ...5 Reviews
HobbyKing
FRSKY L9R 9/12CH S.BUS ACCST LONG RANGE RECEIVER (NON-TELEMETRY)
FrSky L9R long range receiver has just raised the ..." />
| • Longer operating range | 2 times of the operating range for X-series receiver |
| • More channels | 1~9ch from conventional channel outputs, 1~12ch from SBUS port |
Dimension:, Weight:, Antenna:, Number of Channels:, RSSI output:, Operating Voltage Range:, Operating Current:, Operating Range:, Compatibility:, Note: The L9R receiver is not compatible with FrSky V8, D8, and D16 Mode. The LR9 is a non-telemetry receiver and does not support data hub or smart port functions. The Bind and fail safe setting procedures vary from previous X series receivers, please see the instruction manual for details.,
The FrSky L9R long range receiver has just raised the ...HobbyKing
FRSKY TELEMETRY RECIEVER UPGRADE USB/SERIAL LEAD INTERFACE
| FrSky D series Telemetry Reciever Upgrade (light) | FrSky Telemetry Reciever upgrade USB/Serial lead interface |
5 Reviews
HobbyKing
FRSKY TFR4B 2.4GHZ 4CH SURFACE/AIR RECEIVER FAAST COMPATIBLE
| FASST 2.4G | Air Systems (7CH Mode/Multi Mode) & Surface Systems (C1 Mode) (3PK 4PK/4PKS etc.) |
| FrSky TF Modules | TF-8M, TF-14M |
| Compatible with FASST 2.4G | Air Systems (7CH Mode/Multi Mode) & Surface Systems (C1 Mode); |
| Operating Voltage Range | 3.5V~10V |
| Dimension | 42x19x7mm |
| Weight | 5.0g |
Compatibility:, Features:, Specifications:, Number of Channels:4, Operating Temperature Range:, -10~80 degree Celsius,
Light weight and compact in size, the TFR4B is a ...5 Reviews
HiModel
FRSKY UPGRADE CABLE FOR SENSOR HUB & DFT/DJT/DHT/8CH TELEMETRY RECEIVERS FUC-3
, , , , , , Specifications:, , , , , , , , , , , FrSky Upgrade Cable for Sensor Hub & DFT/DJT/DHT/8ch telemetry receivers FUC-3, , ,
Includes/Requires: Includes: 1 x USB PC cable set FUC-3HiModel
FRSKY TWO-WAY 2.4G 8-CHANNEL RECEIVER D8R-II PLUS
| Model | D8R-II plus |
| Weight | 16.2g |
| Dimension | 54*27*17mm |
| Operating Voltage Range | 4.0V-7.2V |
| Operating Current | 100mA |
| Specified Range | 1.5km (Ground Range) |
| Resolution | 11bit (3072) |
| Latency | 22ms |
| Number of Channels | 8CH |
| Analog voltage | 0~3.3V |
, , , , , , Specifications:, , , , , , , , , , , Receiver specifications:, Compatible with FrSky Two Way module DFT/DJT., (V8 receivers work with DFT/DJT, just in receive-only mode.), , ,
Features: THIS IS THE NEW D8R-II PLUS VERSION. Features a) ...2 Reviews