SDSHobby
HOBBYWING SKYWALKER 40A RC BRUSHLESS SPEED CONTROLLER/ ESC FOR RC QUADCOPTER
The difference of Skywalker-40A and Skywalker-40A-UBEC:, Skywalker-40A (PN=80060020):, Linear mode BEC, 2-3S Lipo, Skywalker-40A-UBEC (PN=80060140):, Switch mode BEC, 2-4S Lipo, Specification:, Output:, Continuous 40A, Burst 55A up to 10 seconds, Input Voltage:, -3S Lipo, 5-9 cells Ni-MH, BEC:, 3A / 5V linear mode BEC, Refresh rate of the throttle signal:, 50Hz to 432Hz, Max Speed:, 10000rpm for 2 Poles BLM, 70000rpm for 6 poles BLM, 35000rpm for 12 poles BLM (BLM = Brushless Motor), Size:, 68mm*25mm*8mm, Weight:, 39g, :, Banana Cathode Plug, Features:, Safety Arming Feature:, Regardless the throttle stick position, the motor will not spin after battery connected., Throttle Calibration Function:, Throttle range can be calibrated to be compatible with different transmitters, 1. Brake:, on/ off, . Battery Type:, Lipo/ Ni-MH, 3. Cut-off Mode:, soft-cut/ hard-cut, 4. Cut-off Threshold:, Low/ Medium/ High, 5. Start Mode:, normal/ soft/ super soft, 6. Timing:, Low/ Medium/ High, Multiple Program Methods Supported:, transmitter stick, LED Program Card. Very easy to program the ESC at home or at the flying field, Full Protection:, Low voltage cutoff protection / Over-heat protection / Throttle signal loss protection,
Plug (need to buy separately) (3pcs), T Anode Plug (1pcs) ...SDSHobby
KV690 BRUSHLESS OUTRUNNER DISK MOTOR 4822 FOR RC QUADCOPTER, MULTICOPTER
Specifications:, KV Value:, 690, Motor Diameter:, 47.5mm, Motor Length:, 2mm, Shaft Diameter:, 6mm, Pole Number:, 2 poles, No Load Current:, 0.85A /7.4V, Net Weight:, 98g, Support Lipo Cell:, 4S, Max. Burst Current:, 2A, Working Current:, <16A, Max. Power:, 320W, Internal Resistance:, 0.052ohm, Recommended Propeller:, 12*3.8, Features:, Package Lists:,
Banana plugs not included, suggest welding with ESC plug HL ...SDSHobby
DYNAM UBEC 5A (SWITCH-MODE) FOR RECEIVER, GYRO, SERVO
| Output Voltage | 5V@5A or 6V@5A (Selectable by using a jumper connector) |
| Output Current | Continuous 5A, burst 7.5A |
| Input | 7V-30V (2-6S Lipo battery) |
| Size | 48mm*27mm*10mm (L*W*H) |
| Weight | 30g |
Features:, The 5A-HV-UBEC is a switch-mode DC-DC regulator works with 2S to 6S Lipo battery, and outputs a consistent safe power supply for your receiver, gyro and servos., Specification:, Features:, Uses advanced switch mode DC-DC regulator IC.,
It is very suitable for large scale electric powered RC ...SDSHobby
HIGH QUALITY 200 METER HEAT SHRINKABLE TUBING DIA. =3MM (RED, BLACK ,BLUE,YELLOW COLOR)
| Type | 3mm |
| Color | Red, Black ,Blue,Yellow |
| Length | 200 meter |
| Material | PVC |
| Working Temperature | -55 to 125 Celsius Degree |
| Temperature Resistance | 105 Celsius Degree |
| Shrink Ratio | ≥48±5%, 2 |
| Nominal Voltage | 300V |
Specifications:, Application:, The heat shrinkable tubing is mainly used for wire connection, solder joint protection, electronic device protection and insulation treatment, metal surface protection etc.,
SDSHobby
ALUMINIUM ALLOY SOLDERING STATION FOR QUADCOPTER/ HEXRCOPTER/ 8-AXIS AIRCRAFT
| l Weight | 0.13kg |
Product Description:, The size of Soldering Station:,
l Use aviation aluminium and CNC technology. It’s quite light ...SDSHobby
6STARHOBBY HEAVY DUTY METAL DUAL POWER SWITCH (WITHOUT FUEL DOT) FOR RC AIRPLANE, RC HOBBY- RED/ BLACK/ BLUE
| Note | There is 1-2mm slight error for the manual measurement. |
Mounting Size:, L1=61mm, Features:, Two Switches: one for connecting and disconnecting the receiver circuit, another one for connecting and disconnecting the CDI circuit., Two plugs compatible with JR and FUTABA: One for connecting with receiver battery, another one for connecting with the CDI battery to supply power without opening the canopy., Application Fields:, Suitable for gasoline airplanes, nitro airplanes and model boats,
L2=53mm D1=2mmSDSHobby
HML850 RETRACTABLE LANDING GEAR FOR S800 EVO/ T810/T960 HEXCOPTER OCTOCOPTER FRAME
Product Description:, 1. The retractable landing gear is designed for, . Installation is very simple, just two minutes. The whole weight is about 750g. Recommended hexcopter octocopter frame:, wheelbase is between 800mm-1050mm, flying weight is less than 10KG, Tips:, 1. If the switch channel has,
This product is temporarily out of stock. If you need, ...SDSHobby
BURST FLASH LED LIGHTS SET 1W FOR QUADCOPTER/ HEXRCOPTER/ OCTOCOPTER/ MULITICOPTER- WHITE/ RED/ BLUE/ GREEN/ YELLOW
| For Quadcopter | control board* 1 + connecting line* 4 + LED lights* 4 |
| For Hexrcopter | control board* 1 + connecting line* 6 + LED lights* 6 |
| For Octocopter | control board* 1 + connecting line* 8 + LED lights* 8 |
Recommended:, special light control board, Recommended Set for Multicopter:, Kindly Remark:,
( LED02-B ) special 60cm light connecting line ( LED02-X ...SDSHobby
HIGH IMITATION RC 360 DEGREE ROTATION SMALL NIGHT FLASH LED LIGHT/ POLICE CAR LIGHTS FOR 1/8 1/10 1:8 1:10 RC MODEL CARS
| Working Voltage | 4.8-6V |
| Flashing Mode Works | seven |
| Mode 1 | Power default mixed flashing modes, each mode with one cycle |
| Mode 2 | All lights off |
| Mode 3 | Left and right LED flash alternatively |
| Mode 4 | Left and right LED flash alternatively quickly |
| Mode 5 | All the lights flash |
| Mode 6 | Light flashes back and forth inside and outside |
| Mode 7 | The light flash rapidly back and forth inside and outside |
Installation Steps:, 1. Electric vehicle/ oil motor car installation:, . Power supply using special attachment plug, the voltage is 4.8-6V, connected to receiver start lighting, Specifications:, l, Kinds of Flashing Mode:, n, Remote control way: plug the receiver channel 3, switch remote control of the channel 3, every time switch the switch while switch one flashing mode,
3. from 360 degrees direction equalization astigmatism, high irradiation, the ...SDSHobby
NEW MINI SERVO DISTRIBUTION BOARD/ SECTION BOARD (4106#) WITH LED SCREEN/ VOLTAGE ALARM/ BEC-BLACK COLOR
| (Max | 30A), providing ample work for the servo currents. |
| Input Voltage | 6-13V |
| Output Voltage | 4.8-9 .7 V (factory voltage is 5.2V) |
| Output Current | 0-20A (Max |
| Weight | 80g |
| Size | 122mm*72mm*18mm |
| Working Temperature | -20 to 85 Celsius degree |
NEW Features for Servo Distribution Board:, 1. with LED Screen, Features:, l, You can freely set the alarm input battery voltage, CDI-powered battery alarm voltage value (alarm value range: 4-12V, use the tips alarm buzzer and LED), Technology Parameters:, l,
. Voltage Alarm 3. Flight Time Calculation Dual power inputs ...SDSHobby
30A ELECTRONIC SWITCH WITH JST PLUG FOR RC MODEL LED LIGHT
| Max Current | 30A |
| Voltage | 3.7~28V |
| Power line signal line is made of 18AWG silicone wire with JST plug (female | Input; male |
| Length of power line | about 20CM |
| Weight | about 12g |
Features:, Specifications:, Instructions:, This electronic switch is recommended to use two sections control switch;,
Small size and light weight Resistant to high current Simple ...SDSHobby
XQ POWER 16.5KG RC MODEL BRUSHLESS DIGITAL SERVO XQ-S4615D WITH TITANIUM ALLOY GEARS HIGH GRADE
Specification:, , Weight:, , Size (Length*Width*Height):, , Speed:, , Torque:, , Voltage:, , Bearing quantity:, Horn gear spline:, 5T, Splash water resistance:, Yes, Connector:, , Features:,
62g 40.2mm*20.1mm*38.8mm 0.1sec/60 ° at 4.8v; 0.08sec/60 ° at 6.0v ...SDSHobby
XQ POWER 21KG/56G DIGITAL SERVO XQ-S4120D HIGH VOLTAGE 8.5V WITH TITANIUM GEAR/ALUMINUM CASE
Specifications:,
SDSHobby
XQ POWER 16KG/57.5G DIGITAL SERVO XQ-S4016D WITH TITANIUM GEAR/ALUMINUM CASE
Specifications:,