HobbyWireless
T1024 TRANSMITTER 2.4GHZ 1000MW - LAWMATE
| Weight | 30g (transmitter only) |
| Transmission power 50-ohm load CH1 Vcc = 12V | 30dBm |
| Nominal output impedance | 50 ohms |
| Operating voltage | Vcc, 10.5V (minimum), 12V (typical), 13V (maximum) |
| Supply current Vcc = 12V | 450mA (typical), 500mA (maximum) |
| Video input voltage 75-ohm impedance | 1Vp-p |
| Audio input voltage 10k ohm impedance | 1Vp-p |
| Sub carrier frequency | 6.5MHz |
| Operation temperature | -10 to 40 degrees Celsius |
| Storage temperature | -40 to 80 degrees Celsius |
| Operating humidity | 20 to 80% |
| Storage humidity | 10 to 80% |
| Dimension and weight Excluding SMA connector | 50 x 26 x 13mm, 20g |
| to see the transmitter and camera connections. Note | BNC to RCA adpater is sold separately in accessories. |
Details:, This transmitter is a power house, providing a 1000 miliwatts of pre RF output., :, , Specifications:, , Standard shipping package:, , Disclaimer:, Hobby Wireless is not responsable any damage, loss, illegal operation or changes made by the user to the transmitter will be totally the user's responsibility.,
It has eight (8) selectable channels and it is the ...HobbyWireless
SPEKTRUM/JR (TM) INTERFACE CABLE (CAB-SPEK)
| Web Site | http |
| BELLEVUE, WA 98006 Phone | 425-614-0450 |
Details:, NEW:, Spektrum/JR (TM) Interface Cable (CAB-SPEK), Connects between your Spektrum "FlightLog" data port and the eLogger V3's GPS port. Use a servo Y cable to use your FlightLog display simultaneously! NOTE: make sure your RX has the data port before ordering., E-mail:, sales@eagletreesystems.com,
Now use your eLogger V3 to see Spektrum/ JR Rx ...HobbyWireless
PLASTIC PITOT TUBE KIT (PITOT-KIT-STD)
| Web Site | http |
| BELLEVUE, WA 98006 Phone | 425-614-0450 |
Details:, , E-mail:, sales@eagletreesystems.com,
Our original plastic pitot tube with approx 3 feet of ...HobbyWireless
BATTERY BACKUP HARNESS (CAB-BAT-BACK)
| Web Site | http |
| BELLEVUE, WA 98006 Phone | 425-614-0450 |
Details:, , Description:, , E-mail:, sales@eagletreesystems.com,
Battery Backup Harness (CAB-BAT-BACK) Lets you power your eLogger from ...HobbyWireless
APC 9 X 7.5 THIN ELECTRIC PROPELLER
Details:, , Description:, APC 9 X 7.5 THIN ELECTRIC PROPELLER,
HobbyWireless
CURRENT SENSOR FOR DRAGON OSD
Details:, , Description:,
This a Dragon OSD 80 Amps current sensor with built-in ...HobbyWireless
SANDISK 16GB MICROSD SDHC CLASS 4 MEMORY CARD + SD ADAPTER
| SanDisk MicroSD has great performance and capacity to the SD card family | microSD High Capacity (microSDHC) 16GB flash card. |
| Speed performance rating | Class 4 (based on SD 4.00 Specification) |
Details:, Model:, , Brand :, , Type :, , Speed :, , Capacity :, , Size:,
High storage capacity (16GB) for storing essential digital content such ...HobbyWireless
FY-30A PRO IMU FLIGHT STABILIZATION SYSTEM - BLACK ALUMINUM
| Download FY30A Firmware Upgrade Procedure | Click Here |
| Download USB TTL Cable Driver for Windows 7 | Click Here |
| Download USB TTL Cable Driver for Windows XP | Click Here |
| Download Firmware Uploading Software | Click Here |
| Download FY30A Firmware (.bin file) | Click Here |
| Rate | 4HZ per second. |
Details:, New firmware for fixed wind and Multi-Rotor aircraft., The FY-30A also has an integrated three-axis gyro and three-axis accelerometer which controls the aircraft movement in three-dimensional space. By using your remote control, the unit ca be turned on or off for the following functions:Level flight, Package Includes:, ● 1 x FY-30A Pro circuit board., FY-20A and FY-30A Pro Comparison:, , Data output available:, ,
Click here for firmware and instructions. Multi-rotor instructions can found ...HobbyWireless
FEIYU - TTL TO USB CABLE FOR SETTING AND FIRMWARE
Details:, The USB to TTL cable will give you access to the settings and firmaware of your FeiYu products., USB Driver:,
To use this cable you will need the drivers USB-TTL ...HobbyWireless
CCD KILLER CAMERA 420 LINES - PAL (CAMERA ONLY)
| Dimensions | 21x28mm (camera case only). |
| White | Left Audio Signal |
| Yellow | Video signal or Video feed |
| Black | (-) Negative or Ground |
| Red | (+) Positive |
Details:, , Watch the performance of this little camera:, , Specifications:, , Wires & Functions:, Green: Right Audio Signal (most transmitters are not stereo (mono). You can use either left or right audio signal),
A CMOS camera whose performance rivals CCD at half the ...HobbyWireless
900MHZ BLUEBEAM ANTENNA OMNI SET TUNED FOR 910 MHZ - RHCP SMA MALE
| Weight | 9g (each antenna) |
| Connector | SMA connector |
Details:, The BlueBeam antenna set is a direct fit circularly polarized antenna replacements for your whip antennas., Note:, We recommend using the BlueBeam antenna for receiver and transmitter for best results.,
These will greatly increase your video range and clarity. Place ...HobbyWireless
AN1208 HIGH GAIN PATCH ANTENNA 1.2 GHZ 8DBI - SMA MALE
| < 1.5 | 1 avg. |
Details:, High Gain Antenna Wide Reception Beam.This is a great upgrade for your stock whip antenna.,
It increases not only increase the range, but it also ...HobbyWireless
1.2GHZ & 1.3GHZ BLUE BEAM ULTRA ANTENNA SET - RHCP -SMA MALE
| Length | 2″ 50mm |
Details:, , Connector type:, SMA connector,
The BlueBeam Ultra antenna set is mounted on a small ...HobbyWireless
2.4 GHZ BLUEBEAM ANTENNA WHIP SET - RHCP
| Weight | 9g (each antenna) |
| Connector | SMA Male |
Details:, The BlueBeam antenna set is a direct fit circularly polarized antenna replacements for your whip antennas.,
These will greatly increase your video range and clarity. Place ...HobbyWireless
LOW PASS SMA FILTER FOR 433 MHZ LONG RANGE TRANSMITTERS
| • Operating Temperature | -40°C to 85°C |
| • Storage Temperature | -55°C to 100°C |
Details:, Low pass filter is highly recommended to have if you're using a 433MHz long range system., Insertion loss:, -0.38dB at 433 MHz, Maximum Ratings:, • +36dBm (4 Watts),
This filter is connected between the antenna and your video ...