ngHobbies
SPEKTRUM SATELLITE DIVERSITY CONTROLLER
| Connector 1 | Connection to the flight controller |
| Connector 2-5 | Connection to satellite receivers |
Binding Instructions:, As any spektrum receiver, the diversity board and the satellite receivers connected to it will have to be bound to your spektrum transmitter. To enter the binding mode, you will need to hold the binding button pressed while powering on the circuit. All attached satellite recievers will be blinking fast during binding mode. The LED on the diversity receiver board will blink briefly 3-6 times, then it will turn off for a few seconds after which it will start flashing again - waiting for the RC signal. At this point follow the instructions of your RC transmitter to turn it on in binding mode. When the RC binding signal is detected, the satellite receivers will follow their routine of binding and blink slower. When the binding is complete, the LED's on the satellite recievers will stay on and on the diversity board will turn off., The package contains:, 1 x MK Diversity Controller, Documentation:, Additional documentation translated by google:, Click here,
This litte diversity controller has been designed to connect 4 ...ngHobbies
3DR PIXHAWK AUTOPILOT W/O GPS AND PPM ENCODER
| • Weight | 38g (1.31oz) |
| • Width | 50mm (1.96") |
| • Thickness | 15.5mm (.613") |
| • Length | 81.5mm (3.21") |
Note: Pixhawk is a PPM-input autopilot, which means that it gets RC input from a single cable to the receiver, either via the PPM port, the Futaba S.BUS port, or the special satellite receiver port for Spektrum gear. Most modern RC receivers (and all those sold by 3D Robotics) allow for PPM output, but some, such as non-S.BUS Futaba receivers, do not., Pixhawk includes:, • Pixhawk autopilot, Microprocessor:, • 32-bit STM32F427 Cortex M4 core with FPU, Sensors:, • ST Micro L3GD20 3-axis 16-bit gyroscope, Interfaces:, • 5x UART (serial ports), one high-power capable, 2x with HW flow control, Power System:, • Ideal diode controller with automatic failover, Weight and Dimensions:,
Pixhawk is an advanced autopilot system designed by the PX4 ...ngHobbies
FORCEFLY
| http | //nghobbies.com/forum/index.php?topic=100.0 |
Demo Video:, Features:, Fully programmable flight control:, Control the aircraft roll, pitch, and yaw (twist grip) with one hand, as well as throttle, programmable settings allow complete configuration of each axis – travel adjustment, dual rates, exponential, reverse, trim, etc., Force feedback control:, Active force feedback – pushes the flight stick according to changes in aircraft attitude, Gyro Stabilisation:, Mixes gyro feedback directly to control axes to provide automatic gyro flight stabilization, Model memory:, Save up to eight different models in the ForceFly, PPM Channel Assignment:, Assign any axis to any output channel, Interface ports:, Optional head tracker interface (also for future expansion), Pacakge content:, - ForceFly circuit, Fully Supported Joystick:, - Logitech G940 Flight System (Highest Recommandation), Limited Support for:, - Microsoft Sidewinder 2, Documentation:, Quick Start Manual:, Click here, Detailed user guide on Wiki:, Click Here, Support thread:, New Firmware:, On October 7th, 2011, Version 1.10 firmware has been released. The firmware can be uploaded to all revious Forcefly versions as well using the PicKit 3 programmer kit, available here:, Pickit 3, A full documentation for the firmware upgrade procedure is still pending, till then you can download the firmware by clicking on the following link:, Download Firmware Version 1.10,
The ForceFly is another exciting FPV tele-presence product from EMR ...ngHobbies
FLIGHT CONTROLLER ME 2.1
| Note | This item is pre-order only! |
The following items are included in this kit:, , New in version 2.1 (ME):, High quality MEMS gyros from Analog Devices,
This is the latest Flight Controller ME 2.1 kit for ...ngHobbies
DIVERSITY DUO 5.8 RECEIVER
| Receiver sensitivity | -85dBm |
| Frequencies | 5740, 5760, 5780, 5800, 5820, 5840, 5860MHz |
| Weight | 200 grams |
| Size | 80 x 100 x 23mm |
| Input voltage | 6 – 12V at 500 mA (3s Lipo Ideal) |
| Documentation | Coming soon |
Features:, A/V receiver with two (diversity) antenna inputs -,
The Immersion RC's Diversity Duo receiver is the best diversity ...ngHobbies
600MW 5.8GHZ COMBO
| Receiver sensitivity | -90dBm |
| Frequencies | 5720, 5740, 5760, 5780, 5800, 5820, 5840, 5860 and 5880MHz |
| Weight | 70 grams |
| Size | 72 x 43.5 x 11mm |
| Input voltage | 6 – 18V at 200 mA (2 or 3s Lipo Ideal) |
| Operating Frequencies | 5720, 5740, 5760, 5780, 5800, 5820, 5840, 5860, 5880MHz |
| Weight | 42 grams |
| Size | 45 x 28 x 18mm |
| Input voltage range | 8-12V |
The package contains:, 1 x Highly integrated mini 5.8GHz 600 mW transmitter with cooling fan, so it can be installed in closed spaces as well., Receiver:, A/V receiver with one antenna input, Transmitter:, 600mW output power, Documentation:, N/A, use the connection diagram in the photo below for connection clarification., Power Plug:, Middle pin positive, Manufacturer warranty:, 3 months from the date of purchase,
This is a combo deal for a plug and play ...ngHobbies
MINI 5.8GHZ RECEIVER
| Receiver sensitivity | -90dBm |
| Frequencies | 5720, 5740, 5760, 5780, 5800, 5820, 5840, 5860 and 5880MHz |
| Weight | 70 grams |
| Size | 72 x 43.5 x 11mm |
| Input voltage | 6 – 18V at 200 mA (2 or 3s Lipo Ideal) |
Features:, A/V receiver with one antenna input, Documentation:, N/A, see the below pictures for connectivity diagram and connection., Power plug:, Middle pin positive, Note:, This receiver may not be 100% compatible with Fatshark and Immersion transmitters even if the frequencies match.,
The Mini 5.8Ghz receiver is the smallest on the market ...ngHobbies
VIDEO OSD EXPANDER
All parameters available with the Eagle Tree eLoggers and Data Recorders + optional sensors will be supported for display on the OSD. Here are some examples:, GPS Parameters (Distance to Home, Home Arrow, GPS Altitude, Ground Speed, Course, and more), Manual:, Click here,
The Eagle Tree OSD Expander provides a simple and easy ...ngHobbies
VIDEO OSD PRO EXPANDER
All parameters available with our eLogger V3 and Data Recorders + optional sensors will be supported for display on the OSD Pro. Here are some examples:, GPS Parameters (Distance to Home, Home Arrow, GPS Altitude, Ground Speed,Course, and more), Advanced Features:, The OSD PRO advanced features include "RADAR," Voice Alerts, Return to Home,failsafe, and Waypoints., :, The plane icon labeled “RADAR” above serves two purposes: the direction the icon is pointingindicates your present course. And, the location of the icon on the screen provides a synthetic map, similar to RADAR: the center of the screen marks the takeoff point, in a "bird's eye" view, and the plane icon moves around the screen indicating your model’s location. The maximum distance and the “up” direction is configurable., Voice Alerts/Variometer:, Imagine hearing the status of your model through earbuds connected to your video receiver! The OSD Pro fully supports voice warnings and status updates, via theaudio channel of your video transmitter. Most of the available parameters can be programmed to provide voice alerts., For example, you can program the OSD Pro to periodically update you on altitude once a minute: “Altitude 3-9-1 Feet”. And, you can also program a low voltage warning “WARNING- Voltage 12-point-5 Volts”. Voice alerts can be combined with your camera’s microphone, so you do not lose motor or other flight sounds when there are no alerts., Return to Home and Failsafe:, , Flight Simulator:, A built-in flight simulator is included, letting you fly the RADAR icon around the screen, controlling altitude, throttle and turns with your RC Radio. Since the control surfaces of your model will move at the same time, this feature makes it easier to configure Return to Home and test your alarms and settings, and is also fun on rainy days!, Waypoints:, Up to 3 waypoints (within visual range of the takeoff point) can be programmed into the OSD Pro, for aerial photography or just for fun. The locations of the waypoints are displayed on the RADAR display,
The OSD Pro is a powerful, modular, fully configurable Video/Audio ...ngHobbies
UNO 5.8GHZ V2 RECEIVER
| Receiver sensitivity | -85dBm |
| Frequencies | 5740, 5760, 5780, 5800, 5820, 5840, 5860MHz |
| Weight | 120 grams |
| Size | 80 x 70 x 22mm |
| Input voltage | 6 – 13V at 500 mA (3s Lipo Ideal) |
| Documentation | Coming soon |
Features:, A/V receiver with one antenna input,
The Immersion RC's 5.8Ghz UNO V2 receiver is the scaled ...ngHobbies
1200MW 5.8GHZ COMBO
| Receiver sensitivity | -90dBm |
| Frequencies | 5720, 5740, 5760, 5780, 5800, 5820, 5840, 5860 and 5880MHz |
| Weight | 70 grams |
| Size | 72 x 43.5 x 11mm |
| Input voltage | 6 – 18V at 200 mA (2 or 3s Lipo Ideal) |
| Operating Frequencies | 5720, 5740, 5760, 5780, 5800, 5820, 5840, 5860, 5880MHz |
| Weight | 67 grams |
| Size | 70 x 36 x 18mm |
| Input voltage range | 8-14V |
The package contains:, 1 x Highly integrated mini 5.8GHz 1200 mW transmitter with cooling fan, so it can be installed in closed spaces as well., Receiver:, A/V receiver with one antenna input, Transmitter:, 1200mW output power, Documentation:, N/A, use the connection diagram in the photo below for connection clarification., Power Plug:, Middle pin positive, Manufacturer warranty:, 3 months from the date of purchase,
This is a combo deal for a plug and play ...ngHobbies
100MW 5.8GHZ FATSHARK TRANSMITTER
| Operating Frequencies | 5740, 5760, 5780, 5800, 5820, 5840, 5860MHz |
| Weight | 20 grams |
| Size | 57 x 34mm |
| Input voltage range | 6 - 16 v |
Parameters:, 100mW output power, Content of the package:, 1 x 100mW Transmitter module, Note:, The use and operation of this product in most states, countries may require a HAM or Amateur radio license. New Generation Hobbies cannot be held responsible for your actions if you use this product without proper licensing.,
The Fatshark 5.8Ghz 100mW transmitter is a state of art ...ngHobbies
25MW 5.8GHZ IMMERSIONRC TRANSMITTER
| Operating Frequencies | 5740, 5760, 5780, 5800, 5820, 5840, 5860MHz |
| Weight | 20 grams |
| Size | 57 x 34mm |
| Input voltage range | 6 - 16 v |
Parameters:, 25mW output power, Content of the package:, 1 x 25mW Transmitter module, Note:, The use and operation of this product in Canada and United States will require a HAM or Amateur radio license. Please check with your local authorities before purchasing this product.,
The Immersion RC's 5.8Ghz 25mW transmitter is a state of ...ngHobbies
600MW 5.8GHZ IMMERSIONRC TRANSMITTER
| Operating Frequencies | 5740, 5760, 5780, 5800, 5820, 5840, 5860MHz |
| Weight | 20 grams |
| Size | 57 x 34mm |
| Input voltage range | 6 - 16 v |
Parameters:, 600mW output power, Content of the package:, 1 x 600mW Transmitter module, Note:, The use and operation of this product in Canada and United States will require a HAM or Amateur radio license. Please check with your local authorities before purchasing this product.,
The Immersion RC's 5.8Ghz 600mW transmitter is a state of ...