SDSHobby
Å·²Ä¸‹ÆŽ¶SPEKTRUM 2.4GHZ DX6I RADIO SYSTEM MADE IN CHINA VERSION
| Airplane Programing Features | Flaps, P-mixes, Dual aileron, V-tail, Delta, Differential |
| Package | Radio 1pcs |
| Receiver | AR6100E receiver |
Heli Programming Features: Gyro adjust, Graphic throttle curve, Graphic pitch curve, P-mixes, Revo mix, Swash type (Normal, and CCPM 120),
DX6i Key Features Full range 2.4GHz DSM2 6-channel radio 10-model ...SDSHobby
PIXHAWK PIX PXI PX4 OPEN-HARDWARE AUTOPILOT FLIGHT CONTROLLER SET (AUTOPILOTS FC/ CONTROL BOARD WITH 6H GPS) FOR RC AIRPLANE/ MULTICOPTER
| . CPU | 168MHZ, 256K RAM |
Kindly Remark:, 1. The product is, :, Their positioning accuracy, speed and sensitivity are the same. The only difference is that, Weight and Sizes:, 1. Weight:, 38g (not include GPS), . Width:, 50mm, 3. Height:, 15.5mm, 4. Length:, 81.5mm, Features:, 1. Advanced, Hardware Specifications:, Processor:, 1. 32-bit 2 Mega STM32F427 Cortex M4 core with FPU, Interfaces:, 1. 5 x UART (serial ports), one high-power capable, 2x with HW flow control, Attention:, Pixhawk is a PPM-input autopilot, which means that it gets RC input from a single cable to the receiver, either via the PPM port, the Futaba S.BUS port, or the special satellite receiver port for Spektrum gear. Most modern RC receivers (and all those sold by 3D Robotics) allow for PPM output, but some, such as non-S.BUS Futaba receivers, do not.,
open-hardware and not support sales return after selling out. If ...