Skip to content

ReadyMadeRC

AIR TITAN KIT (HARDWARE INCLUDED) WITH MOTOR, ESC, AND SERVOS

ATTENTIONAccording to
Wingspan2520MM/ 99.2inch
Kits Airplane weight2.4kg(5.3IB) including all reinforcement parts
Extra Payload3.0kg-4.0kg (6.6IB-8.8IB)/ flight weight>6.0kg
Customized Motor for AirtitanM60K/ Power 1500W
Testing static thrust5.5-6.0kg (6S, 15" Prop)
Propeller recommend15*6 / 15*7
ESCAdvanced 80A OPTO (without Built-in BEC)
External UBEC5V/6A,5.5V/6A or 6V/6A (Switchable)
Material of fuselage and WingEPO
​​RMRC 6s batteries found here10,000 mAh
Main-wingbuilt- in 4PCS alloy aluminum plus 2PCS carbon tube through the Main-wing
Control surface of Aileron and Elevatorcarbon tube reinforced, no need further DIY

Breakdown for Transport:, This plane carries over the “gentle stall” characteristics of the Penguin, but super sized. No scary tip-stalls. Instead, it has super predictable flight characteristics. Tricycle landing gear with a steerable nose gear is included, along with a stable high wing design, plus a bottom camera port, and secondary top camera mounting area. The ARF version includes an 80A OPTO ESC, Massive 1500W motor, a switch mode 5-6V adjustable UBEC, and heavy duty metal geared servos for the ailerons, elevator, and steering. Hand launch is possible, but you might need to work out a bit before you try it (see beginning of video!). Like the Penguin, this airframe was designed with FPV in mind, but would also serve as a great plane to fly at the field if you just want something you can strap a GoPro to, or maybe even 10 of them since it won’t mind the weight. Available and ready to ship now at Ready Made RC, LLC, the best place to get ALL your FPV and RC equipment!, Specifications:, , Customized Brushless Power system:, Servos:, , Battery Recommendations:, , Sample Battery Setup:, , ​​Flight Recomendations:, *Note : 5S with a 15*8 Prop is okay if your flight weight is less than 5.5kg. A 6S pack will however provide “better power", *Note: Flight weight of 5.5kg-6.0kg can meet most FPV requirements, and we recommend less than 6.0kg for most FPV pilots, High Quality Reinforcement :, ,

UN1133 shipping regulations, the glue contained in t his product ...

ReadyMadeRC

BLACKOUT MINI H QUAD FRAME

Frame WeightVersion 1
Materials3k Weave Carbon Fiber
FastenersStainless Steel & Black Nylon 6/6
Size220mm diagonally, 175mm wide, 130mm long motor-to-motor; about 1/2 the size of a regular quadcopter
Flight Controller Mount30.5mm x 30.5mm
Board Camera Mount32mm x 32mm
MotorsTiger MN1806 2300kv Motor
PropellerGemfan 5x3
ESC12-15A
Battery3S 1300mah - 1500mah
Flight ControllerCC3D
Flight CameraCCD Camera or RMRC Pico
HD CameraMobius Action Camera

Specifications:, , Version: 2, Maximum Propeller: 5", Motor Mount: M2 12mm - 16mm (Tiger MN1806 2300kv, RCX 1804 2400kv), M3 19mm (Tiger MT2206 2000kv, Sunnysky X2204 2300kv), Features:, , Includes:, , Helpful Information:, , Videos:,

Description The Blackout Mini H Quad is a low weight ...

ReadyMadeRC

PENGUIN V2 ARF WITH M2815 MOTOR AND 60A ESC W/SWITCHMODE BEC

ATTENTIONAccording to
Wingspan1720MM/67.7inch
Length1230MM/48.5inch
Wing Area36dm/3.9ft2 (Mainwing Area)
MotorBrushless motor M2220 Kv1350 or M2815 KV1280
ESC40A for M2220 or 60A for M2815
Servo3pcs 17g servo+ 1pcs 9g servo.
BatteryLi-Po 11.1V 2400 mAh for M2220 and  5000mAh for M2815 recommended
Static ThrustMotor M2220 1.5Kg/53.0oz.
Payload600-1000G/21.5-35.5oz (Payload is the extra weight it can carry besides the standard ARF weight)
MaterialEPO Wing and fuselage/ Wooden rib reinforcement/ aluminum alloy Pipe/Carbon Fiber pipe
Part NoFUP1205
17gServo3PCS/ 9g servo
Propeller 90601PCS
60A ESC Programming manualHERE

ARF Weight:   0.98kg/34.6oz.ARF is the weight including almost ready to fly, not including battery and your extra FPV devices, Forum Discussions:, RCGroups, WANT A CAMERA PAN/TILT SYSTEM? Our pan/tilt units will drop right in to our version of the Penguin using the included wood base mount.  There are a few choices sold separately:, , Finwing Penguin Features:, , Airplane flight video please visit:, www.youtube.com/user/Finwingtube, More high definition photos visit:, www.flicker.com/photos/finwing,

UN1133 shipping regulations, the glue contained in t his product ...

ReadyMadeRC

STROBON NAVIGATION STROBE (RED) WITH WIRE

,

It’s really a powerful strobe with low power consumption (50mA ...

ReadyMadeRC

HIMAX 2815-1400 BRUSHLESS INRUNNER (TWINSTAR)

,

• Designed as direct replacement for Speed 400/480 can motors ...

ReadyMadeRC

SUPER SKY SURFER 2000 PNP

MaterialEPO
Wingspan2000mm(78.74inch)
Flying Weight1500g(53oz)
Motor3536 1000KV Brushless
Servos4*17g  servos
Propeller9x4(Three blade)
Battery11.1V ,3S 2200mAh-3300mAh recommended (not included)

Technical Details:, , Includes:, , Requires:,

Another great option for RC and FPV flight! The Super ...

ReadyMadeRC

EAGLE EYES FPV STATION WITH PLASTIC CASE

, for live PC display of telemetry and firmware update. NoteA standard USB "Mini-B" cable required for these features, but not included.

FPV Station provides all of the following features:, , Here are the specifications:, ,

EagleEyes TM FPV Station Shipments after May 8 2012 will ...

ReadyMadeRC

EASY STAR/SKY SURFER/BIXLER ADJUSTABLE MOTOR MOUNT

Position 1stock height up to a 6" prop.
Position 2(+) 0.41" for up to a 7" prop.
Position 3(+) 1.0" for up to an 8" prop.
Total Weight20g

Three step installation:, , Included:, 1 - Motor Base Tube and Motor Plate, 4 motor screws and 4 mount screws., Notes:, A 35mm outrunner motor will only fit in Position 3 (+ 1.0"). 28mm outrunners will work in any of the three positions. The stock thrust angles are retained in all 3 positions. If a change in thrust angle is desired, simply add a small washer between the motor base and motor plate at the appropriate locations., Compatible Motors:, , Acceptable bolt patterns (units in mm):, 16x16, 16x19, 19x19, 19x25, 25x25,

This CNC machined aluminum two piece mount is designed to ...

ReadyMadeRC

DJI NAZA H - HELICOPTER STABILIZATION CONTROLLER

7.4V0.25
5.8V0.375
Vertical± 0.8m, horizontal
(Naza-H BEC shown in picture is not included with unit ...

ReadyMadeRC

EZUHF JR-FRSKY MODULE TRANSMITTER

- Recommended tx antennaDiamond SRH771
http//fpvlab.com/forums/showthread.php?3000-EzUHF-Rx-Tx-firmware-upgrade-procedure
http//fpvlab.com/forums/showthread.php?2999-EzUHF-Rx-Tx-driver-installation
http//fpvlab.com/forums/showthread.php?2998-EzUHF-Rx-Tx-bind-procedure

Notice: The use and operation of this product in the USA and many other countries requires an amateur/ham radio license, and some countries may forbid its use entirely. It is the responsibility of the purchaser to ensure that the use of this product meets the requirements imposed by your government’s rules and regulations for RF devices. Do not purchase this product if you are unsure of the government requirements or are not able to comply with them.  ReadyMadeRC cannot be held responsible for your actions if you purchase and/or use this product in violation of your government's regulations.,

- 500mW of EzUHF Power - JR Module, compatible with ...

ReadyMadeRC

REVOLECTRIX MULTI-PORT SAFE PARALLEL ADAPTER (MPA) - XH STYLE

Unit includes:, support for safe parallel charging of up to 6 same-cell-count packs at one time (2s-8s); supports 40A max charge/discharge rate; every port reverse polarity fuse protection of main battery wires; every cell/balance wire protected by self-resetting polyfuses with temperature warning indicators; supports non-balanced charge of up to two 1s LiPos used with "indoor models"; supports 1 RX and 1 TX NiCd/NiMH battery pack. Works with any Cellpro charger or battery workstation equipped with "XH MODE WIRING" option. Interconnect cables available separately to support Cellpro PowerLab 6/PowerLab 8, Cellpro 10XP, as well as other brand chargers which are compatible with XH balance plugs and wiring.,

MPA is a Multi-Port Safe Parallel Module for safely interconnecting ...

ReadyMadeRC

FAT SHARK DOMINATOR HEAD TRACKER MODULE

,

Head tracker module for the FatShark Dominator video glasses. When ...

ReadyMadeRC

SKY SURFER RTF BRUSHLESS (1.4M)

Wingspan1372mm (54 inch)
Length915mm (36 inch)
Flying Weight624g (22 oz)
Drive System2620 Brushless
Speed Controller20A
*NOTECurrent version uses bullet type connectors and not deans/t-connector types
Battery11.1V 1300mAh Li-Po  (basic charger included)
*NOTECurrent version uses bullet type connectors and not deans/t-connector types
Control system4 CH 2.4GHz
Radio Control Range3000

*Note: There are people looking at what they are calling "version 1" and "version 2" of this plane.  They really aren't version 1 or 2, but they are just different versions of this plane.  Mine are what people are calling version 1, just as the pictures show.  This is MUCH better for FPV since there is a ton of space inside the fuselage.  The "version 2" planes ruined the usefulness for FPV by putting the servos and control arms inside the fuselage.  The tubes for the control arms add strength to the fuselage in this version.  My store is focused on FPV, so the equipment I carry will be what is best for FPV!, *Not to be distributed or linked to by other companies who like to take other people's work.  You know who you are... :), Servos:, 4X 9g high speed micro, Requires:, , Note for beginner pilots:  Although this plane is super easy to fly, it's a good idea to find local flying help from an experienced pilot.  This can help with the small amount of assembly that is required and with the first flights.  It's difficult to give support remotely when someone is totally new to the hobby, so the local help and help from,

RTF with pre-installed servos, brushless motor , ESC, and 2.4GHz ...

ReadyMadeRC

FPV BEGINNERS COMBO: INCLUDES RTF SKY SURFER, PREDATORV2GOGGLES

This combo includes:, , *Notice: The use and operation of this product in the USA and other countries requires an amateur/ham radio license, and some countries may forbid its use entirely. It is the responsibility of the purchaser to ensure that the use of this product meets the requirements imposed by your government’s rules and regulations for RF devices. Do not purchase this product if you are unsure of the government requirements or are not able to comply with them.  ReadyMadeRC cannot be held responsible for your actions if you purchase and/or use this product in violation of your government's regulations.,

Do you or someone you know want to get in ...

ReadyMadeRC

PENGUIN V2 ARF WITH M2220 MOTOR AND 40A ESC

ATTENTIONAccording to
Wingspan1720MM/67.7inch
Length1230MM/48.5inch
Wing Area36dm/3.9ft2 (Mainwing Area)
MotorBrushless motor M2220 Kv1350 or M2815 KV1280
ESC40A for M2220 or 60A for M2815
Servo3pcs 17g servo+ 1pcs 9g servo.
BatteryLi-Po 11.1V 2400 mAh for M2220 and  5000mAh for M2815 recommended
Static ThrustMotor M2220 1.5Kg/53.0oz.
Payload600-1000G/21.5-35.5oz (Payload is the extra weight it can carry besides the standard ARF weight)
MaterialEPO Wing and fuselage/ Wooden rib reinforcement/ aluminum alloy Pipe/Carbon Fiber pipe
Part NoFUP1201
17gServo3PCS/ 9g servo
Propeller 90601PCS

ARF Weight:   0.98kg/34.6oz.ARF is the weight including almost ready to fly, not including battery and your extra FPV devices, Forum Discussions:, RCGroups, WANT A CAMERA PAN/TILT SYSTEM? Our pan/tilt units will drop right in to our version of the Penguin using the included wood base mount.  There are a few choices sold separately:, , Finwing Penguin Features:, , Airplane flight video please visit:, www.youtube.com/user/Finwingtube, More high definition photos visit:, www.flicker.com/photos/finwing,

UN1133 shipping regulations, the glue contained in t his product ...

BevRC DPCAV Hobby-Lobby HobbyKing LowPriceRC ngHobbies NitroTek R2Hobbies RangeVideo RCTimer ReadyMadeRC HobbyWireless RCPlanet HorizonHobby HiModel OFM GetFPV AMainHobbies SDSHobby GoodLuckBuy Flying-Hobby