Skip to content

ngHobbies

APC SLOW FLYER 12X3.8 PROPELLER

- External diameter12"
- Pitch3.8"
- Mounting hole5mm

Technical Data:, Package contains:, One propeller, manual and rings.,

This is a 12 x 3.8 slow flyer propeller that ...

ngHobbies

FLEXIBLE YELLOW LED STRIP

- Length10cm (6 x LED)
- Voltage required12V
- Mountingremove the protective layer from the bottom to stick it to your MK.

Technical Data:, Package contains:, One strip of 10cm long felxible yellow LED strip with 6 LED's on it.,

This is a felxible high output gyellow LED strip. Usually ...

ngHobbies

MK 1045 PROPELLER MOUNT FOR ROXXY MOTORS

,

MK propeller mount for EPP 1045-propeller, s uitable for MK2832/35, ...

ngHobbies

EPI STORM FOR EPI OSD

The following items are included in this kit:, 1 x EPI-Storm board, What is not included in the kit and it is required:, 1 x Current Sensor, Doumentation in english:, Click here,

The EPI Storm is an open source current sensor for ...

ngHobbies

AT MEGA 1284P WITH BOOTLOADER

,

Preprogrammed Atmel microcontroller for Flight Controller Ver. ME2.1

ngHobbies

MPX4115A PRESSURE SENSOR

,

This is a replacement pressure sensor for the flight controller ...

ngHobbies

APC SLOW FLYER 8X3.8 PUSHER PROPELLER

- Pitch3.8"
- Mounting hole5mm

Technical Data:, - External diameter: 8", Package contains:, One propeller, manual and rings.,

This is an 8 x 3.8 slow flyer pusher propeller ...

ngHobbies

APC SLOW FLYER 14X4.7 PUSHER PROPELLER

- External diameter14"
- Pitch4.7"
- Mounting hole5mm

Technical Data:, Package contains:, One propeller, manual and rings.,

This is a 14 x 4.7 slow flyer propeller that ...

ngHobbies

300MM MIKROKOPTER FRAME

,

This is the small 300mm frame set for the Mikrokopter.The ...

ngHobbies

OPTOKOPTER FRAME

,

This is a replacement Optokopter frame set.The set contains 8 ...

ngHobbies

400MM MIKROKOPTER FRAME

,

This is the standard 400mm frame set for the Mikrokopter.The ...

ngHobbies

QUADRO XL FRAME

,

This is a replacement Quadrokopter XL frame set.

ngHobbies

5 PIN SMD RIGHT ANGLE MOLEX CONNECTOR

,

This is the Molex connector used on the new Quad, ...

ngHobbies

ARXRS610 GYRO PCB BOARD

For building instructions and part lis click the line below:, Mikrokopter wiki,

This is the bare PCB for ADRS10 gyro. This is ...

ngHobbies

RED ALU RIGGER FOR 400MM MK FRAME

,

This is the Red aluminum rigger only, for the 400mm ...

BevRC DPCAV Hobby-Lobby HobbyKing LowPriceRC ngHobbies NitroTek R2Hobbies RangeVideo RCTimer ReadyMadeRC HobbyWireless RCPlanet HorizonHobby HiModel OFM GetFPV AMainHobbies SDSHobby GoodLuckBuy Flying-Hobby