Fokker Dr.1 Triplane 640mm EPO (PNF)
|Weight (Without battery)||378g|
|Flying Weight (with battery)||480g|
|ESC||20A brushless w/BEC|
|Servo||9g x 2, 3.6g x 2|
Features:, Plug n Fly - Just add your own reciever and battery! (not included), Specs:, Motor:, Brushless Outrunner 1200kv, Requires:, Your Own 4 Channel TX/RX,
This superb Fokker Dr.1 is made from tough EPO foam and is not only nicely finished, it has also been extremely well designed, it requires no glue and can be assembled faster than many monoplane models!
There is no shortage of scale detail and the deep scarlet paint and waterslide decals really do look the part, the front cowl is actually metal and there are plenty of nice touches including the windscreen, guns and pilot figure complete with his "silk scarf"! Assembly is super fast, all servo's are pre-installed, as is the brushless outrunner motor and ESC, amazingly, the fuselage section is fully pre-assembled, leaving you to simply attach the wings, which is usually the most laborious part of WW1 models, not this Dr.1! The wing attachment is really fast and simple, in fact this whole model could be assembled in under 1 hour, especially as the tools required are included!
The Dr.1 uses a 3s lipoly (not supplied) and has no shortage of power for the odd loop, the Fokker also has full four channel control and just looks fantastic cruising though the sky. This great model is really nice quality and really looks the part both on the ground and in the air, it is a must for WW1 and scale fans!
Very High Level of Factory Pre-Assembly
Fast Assembly Time
All Assembly Tools Included
High Detail Scale Finish
Genuine Full Metal Cowl
Requires no Glue - Screw Together Assembly
Full Four Channel Control
500mAh~600mAh 3s Lipoly Battery
Found 5 years, 9 months ago