RCModelScout.

SDSHobby

Fh Auto Power-off Digital Caliper 0-150mm

PROBLEM:, 1.Every second 5 digits and Jump simultaneously, :Battery voltage is under 1.45V. Remove cover and replace battery, SOLUTIONS:, Faulty circuit. Remove battery, after 30sec. Put battery back into compartment., SOLUTIONS:, Function buttons and sliders signal end may have shorted out.Remove the cover,, SOLUTIONS:, Spring or rubber covers may be out of shape due to excessive pressing.See, SOLUTIONS:, Sensor may have dirt or deposits in it Remove cover and slider assembly. Blow, SOLUTIONS:, (1) Poor battery contact. Check battery compartment, clean if necessary., Maximum measuring speed :, 1.5m/sec or 60"/ sec, Measuring system :, Non-contaction linear CAP measuring system, Display:, LCD display, minus sign"-",character in 6.35mm/0.25"height for 5 digits,small digit"5", Battery:, One silver oxide battery 1.5V for one year of continuous use. Low battery warning by, Influence of humidity:, Not important within 0 to 80% of relative humidity., Data output:, Serial output for interface with host computer or printer, Data processing interface (option):,

CARE & MAINTENANCE
1. Keep body face clean; prevent liquid material from getting into slider to destroy electronics. Face should be cleaned with a clean,dry,lint-free cloth.
Lubricate body with a few drops of clock oil. Acetone &alcohol; must not be used.
3.Keep battery compartment clean and free of corrosion
TROUBLESHOOTING

SOLUTIONS.Display cannot count
3.Display shows 000.00 or IN 00.000
put the button springs in place with rubber covers. Contact must be unobstructed
4.Function buttons not active
solution above for tips.
5.Reading error for full Length is over 0.1 mm
off sensor face with clean pressurized air( over 51kg/cm squared), clean with dry , lint- free cloth.
6.No display on LCD screen
(2). Battery voltage is under 1.3V.Repalce with correct battery.

SPECIFICATIONS AND FUNCTIONS
Your digital caliper was constructed with quality materials and workmanship and will Give you many
years of free use when cared for as described in the "Care &Maintenance; " section
0--200mm/0-8"
0--300mm/0-12"00-300mm/8-12"
and "IN" sign for inch measuring unit
falshing display
software of quality control
Auto power off

Found 11 years ago