ReadyMadeRC
CURRENT SENSOR FOR DRAGONOSD+ V2
Note: will be shipped with the Deans style t-connectors included, but not soldered on. This will allow users of other connections to easily solder on their own connectors.,
Current Sensor for DragonOSD Manuals for the DragonOSD can be ...ReadyMadeRC
HARD PLASTIC CASE FOR EAGLE EYES FPV STATION
,
Clear case that can be used with the Eagle Eyes ...ReadyMadeRC
FEIYU TTL-USB CABLE FOR CHANGING SETTINGS
| Needed to set PID settings on FY90Q (and FY91Q). Download the PID Setting Software here | FEIYU SOFTWARE |
ReadyMadeRC
SIMPLE OSD 10HZ GPS MODULE V2
| Dimension | 16mm x 16mm x 6mm |
| Max. Update Rate | up to 10Hz |
| Support AGPS function ( Offline mode | EPO valid up to 14 days )S |
ReadyMadeRC
SIMPLE OSD 100A CURRENT SENSOR ULTRA LIGHT WITH WIRES
| Voltage Range | 2.7 to 40V |
| Sensor Shunt Resistance | 0.001 ohm |
| Sensor Gain | 100 (1 volt output equals 10 Amper current) |
| Weight | 1gram (without wires) or 5gram (with 30cm extension wire) |
ReadyMadeRC
2 WAY VIDEO SPLITTER (3-18V)
| Pin orientation | Vertical |
DPCAV
HYPERION SERVO PROGRAMMER
,
The Hyperion Servo Programmer is used to customize the performance ...DPCAV
980MHZ HIGH GAIN YAGI ANTENNA, +10DBI (SPECIAL)
,
This low cost Yagi antenna provides approximately +10dBi of gain. ...DPCAV
AMPLIFIED MICROPHONE WITH VOLUME CONTROL
,
This specially configured Tiny-Mic amplified microphone is designed to plug ...ngHobbies
FORCEFLY
| http | //nghobbies.com/forum/index.php?topic=100.0 |
Demo Video:, Features:, Fully programmable flight control:, Control the aircraft roll, pitch, and yaw (twist grip) with one hand, as well as throttle, programmable settings allow complete configuration of each axis – travel adjustment, dual rates, exponential, reverse, trim, etc., Force feedback control:, Active force feedback – pushes the flight stick according to changes in aircraft attitude, Gyro Stabilisation:, Mixes gyro feedback directly to control axes to provide automatic gyro flight stabilization, Model memory:, Save up to eight different models in the ForceFly, PPM Channel Assignment:, Assign any axis to any output channel, Interface ports:, Optional head tracker interface (also for future expansion), Pacakge content:, - ForceFly circuit, Fully Supported Joystick:, - Logitech G940 Flight System (Highest Recommandation), Limited Support for:, - Microsoft Sidewinder 2, Documentation:, Quick Start Manual:, Click here, Detailed user guide on Wiki:, Click Here, Support thread:, New Firmware:, On October 7th, 2011, Version 1.10 firmware has been released. The firmware can be uploaded to all revious Forcefly versions as well using the PicKit 3 programmer kit, available here:, Pickit 3, A full documentation for the firmware upgrade procedure is still pending, till then you can download the firmware by clicking on the following link:, Download Firmware Version 1.10,
The ForceFly is another exciting FPV tele-presence product from EMR ...ngHobbies
FATSHARK DOMINATOR 2.4GHZ RECEIVER MODULE
,
This is a plugin 2.4Ghz receiver module for the Fatshark ...