Hobby-Lobby
40 Amp Pro SB Brushless ESC
Brake | Yes - Programmable |
Input Voltage | 10.8V - 22.2V |
Momentary Peak Current | 55A (15 sec) |
Length | 2.70 in (68.6mm) |
Width | 1.30 in (33.0mm) |
Height | 0.50 in (12.7mm) |
Weight | 2.2 oz (62g) |
Wire Gauge | 13AWG |
40 Amp Pro Switch Mode BEC Brushless ESC Highlights:, Up to 40-amp continuous current with proper air flow, with 55-amp burst current (15 seconds), Technical Specifications:, 40 Amp Pro Switch Mode BEC Brushless ESC Specs:, Continuous Maximum Current:, 40A with reasonable cooling, Input Connector Types:, 13AWG with E-flite EC3 Connector, Output Connector Types:, 13AWG with 3.5mm Female Gold Bullet Connectors,
Allows you to operate up to 7 analog or 6 digital standard sized servos
The E-flite 40A Pro SwitchMode BEC Brushless ESC is a highquality, innovative and efficient sensorless brushless electronic speed control with an integrated SwitchMode BEC. It can operate without the need for a separate receiver battery to power your servos and receivers, saving you weight and complication. It is capable of up to 40 amps continuous current when using 3 to 6series Li-Po battery packs. You can drive up to 7 analog or 6 digital standard-sized servos with the BEC on any recommended input voltage. This ESC also features an exposed, finned heat sink aluminum case with lightweight plastic endcaps. Additional features include safe power-arming along with advanced programmable features such as low-voltage cutoff, braking, timing, throttle input range, and more, making this truly a "pro series" speed control.
5 volt Switch Mode BEC circuit capable of 2.5-amp continuous current on any recommended input voltage
Drive up to 7 analog or 6 digital standard sized servos with the BEC on any recommended input voltage
3-6S Li Po, 9 to 18 cell Ni-Cd/Ni-MH input voltage
Finned heat sinks
Programmable motor braking
Safe power arm mode prevents accidental starts
Programmable low-voltage cut-off with settings for 3S Li-Po (9V), 4-cell Li-Po (12V), 5-cell Li-Po (15V), 6--cell Li-Po (18V), or 70% of battery starting voltage
Programmable soft start for helis and airplanes
Auto motor shutdown if signal is lost or there is interference
Programmable timing 5 user-selectable ranges for use with a large variety of brushless motors
Programmable throttle input range (1.1-1.9 ms or 1.2-1.8 ms)
Heli mode for starting the motor with a low speed ratio
Utilizes new smaller MOSFETs technology to save weight
Radio System Power On/Off Switch
Pre-wired connectors E-flite EC3 on battery input and 3.5mm female gold bullets on motor output leads
Check price and availability
Found 11 years, 6 months ago