SDSHobby
Futaba S3001 4.1kg/45g Standard Analog Servo with Ball Bearings
Specifications:, No Loading Speed:, 0.28sec/60 degrees at 4.8V ;, Stall Torque:, .4kg.cm at 4.8V ;, Dimensions:, 40.5×20×36.1mm, Weight:, 45.1g, Interface Type:, JR, Bearing Type:, Ball Bearing, Gear Type:, All Nylon Gears, Connector Wire Length:, 305mm, Current Drain (4.8V):, 7.2mA/idle, Current Drain (6.0V):, 8mA/idle, Operating Voltage:, 4.8-6.0 Volts, Operating Temperature Range:, -20 to +60 Degree C, Operating Angle:, 45 Deg. one side pulse traveling 400usec, Features:,
0.22sec/60 degrees
at 6.0V
3kg/cm at 6.0V
This is a Standard Servo with a Ball Bearing on the output shaft. This has a "J" connector and uses a nylon gears.
This servo can produce high-current draw from your batteries. If using Ni-MH or LiPo batteries, make sure they are capable of delivering sufficient amps.
Single top ball bearing same mounting as S148 and S9201 (individual rectangular grommets) 3-pole motor Nylon gears
Check price and availability
Found 11 years ago